Question about 2000 Suzuki Vitara

Open Question

Noisy tappets due to low oil .management shutdown

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

A noisy engine


low oil pressure, wrong oil filter, worn hydraulic lifters , worn rockers at valve stem ends
worn rocker bushes
wrong viscosity engine oil
and engine is spelt ENGINE nt how you spell it

Jan 05, 2016 | Cars & Trucks

1 Answer

How do I repair noisy tappets?


For tappets, you can try spraying GOOD quality penetrating oil down the pushrods to enter the top of the lifters, if they are hydraulic. If mechanical, adjust gap per your shop manual. Fan belt breaking can be due to misalignment of some pulley, or a driven device that doesn't turn easily (bad bearing).

Jun 05, 2015 | Cars & Trucks

1 Answer

My toyota 5a engine tapets are very noisy when running


check your engine oil pressure with a manual gauge, compare it to repair manual specks. if oil pressure is too low and mileage is 80,000 or below you could get by with an oil pump replacement. If miles are lower see if tappets are adjustable and try it. only if oil pressure is good as well. If mileage is higher than 80,000 you may be in the market for an overhaul if oil pressure is low.

Apr 18, 2013 | Cars & Trucks

2 Answers

How do I stop rattly tappet noise?


Rick you don't say what vehicle it is. I don't believe mixing oils will affect tappet noise unless one of the two oils was way too thin a grade.

If all else is OK, rattly tappets aren't generally a big worry unless you also get hard starting, which indicates the valve timing is way off. I've had vehicles in which valve noise was factory standard LOL.

You could try an oil change with one grade heavier.

The rattle might also indicate that the upper cylinder head is being starved of oil, either due to low pressure, or sludging. You could get oil pressure measured to eliminate that possibility.

After all else if you want to go further you could get the valve lash adjusted, but in some motors it is a helluva job, and in a van, it is more difficult.

Aug 27, 2017 | Cars & Trucks

1 Answer

97 elantra 1800 sounds like tappet noise only once engine warms up


sounds like a tappet,could be a ping caused by low grade of gas. hows the oil pressure. sometimes when oil pump is weak it will cause this when car warms up. will also do this if car is overheating...hope this helps some and good luck.

Aug 13, 2012 | Cars & Trucks

1 Answer

Toyota celica 190 bhp tappets are noisy


one or both of two things can cause this

low oil pressure to lifters
or there clearance is not adjusted correctly

clearance should be adjusted with engine hot and idle'ing using a go /no go shim of proper thickness

Jun 29, 2012 | Toyota Celica Cars & Trucks

1 Answer

What is tappet settings


Hydraulic tappets are tappets that contain a small hydraulic piston, pressurised by the engine's lubricating oil supply.[5] Although the piston does not move appreciably or frequently, it acts as a hydraulic spring that automatically adjusts the tappet clearance according to the oil pressure. This makes the valve actuation self-adjusting and there is no need to adjust the rockers. Hydraulic tappets depend on a supply of clean oil at the appropriate pressure. When starting a cold engine, with low oil pressure, hydraulic tappets are often noisy for a few seconds, until they position themselves correctly.


Parts For Porsche Panamera

Jun 15, 2012 | Cars & Trucks

1 Answer

I need the tappet setting code for a 1995 ford econovan.tappets are noisy.


There's NO code for noisy lifters. Depending on miles and previous maintenance (oil changes, etc) your lofters are probably worn. They need to be replaced and you might have an oil pressure test done to make sure there's is adequate oil pressure.

Mar 19, 2011 | Ford Econoline Cars & Trucks

1 Answer

Ford Ranger diesel has noisy tappets until truck


Hi my name is Tom and I am here to help you.

I drove a diesel Chevy and had the same problem.

I reduced the noise by dropping my oil to a lower viscosity at the low end and keeping the high end the same. i.e. If O.E.M. recommends a 10W30 dropped to a 5W30. This will give you coverage at the high side and lower viscosity at the low end.

There are after market additives which are formulated to lubricate the tappets. Any parts store should be able to recommend which is best. Follow the instructions and do not add too much. They contain a "sticky" nature which could defeat the dropping of your lower viscosity.

I trust this answered your question. If I can be of further help, let me know.

Jul 01, 2010 | 2006 Ford Ranger

1 Answer

No oil pressure on an audi 2 liter 20 valve engine Very noisy tappets


Did you check the pressure first? Noisy tappets don't necessarily mean low pressure, sometimes they simply wear out.
Otherwise, either your oil pump is bad, or the oil pickup screen located inside the oil pan area is clogged up. Clean the screen first and then check the pressure...

Jun 26, 2009 | 2002 Audi A4

Not finding what you are looking for?
2000 Suzuki Vitara Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...