Question about 2000 Ford Focus

1 Answer

How to aviod daydream - 2000 Ford Focus

Posted by on

  • Curt Downs May 11, 2010

    drink lots of coffee

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Get a life, maybe

Posted on Sep 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove a truck rear end


It is a Chevy truck. The four leaf sring clamp nuts need to be removed (rear end supported with a hydraulic floor jack or equivalent), disconnect the drive shaft, once again four nuts on two U calmps, drop the shaft out of the way. Then remove the bolts that hold the shocks to the rear axles brackets. Remove the brake lines and cap them off to aviod drainning out the master cylinder. Drop the unit out

Jun 13, 2012 | 1983 Chevrolet Chevy

1 Answer

My ac wont blow cool air


There may be a problem with your a/c compressor or there may be a leak in one of your a/c lines. Most likley your problem is coming from a leak in the system. In order to do a proper stop leak test with dye, it would be advisable to make a trip to your local mechanic and ask for an a/c check. If you want to aviod the shop you can try and use stop leak to see if that works, but chances are if there is no cold air at all then the leak you have is significant.

Hope this Helps!

Jun 07, 2011 | 2005 Kia Optima

1 Answer

My Caravan is good yet,dash board light is not working trying to aviod a mechanic..Can I fix it myself"


CHECK THE INSTRUMENT CLUSTER LIGHTS FUSE.SHOULD BE 10 AMP FUSE.IF FUSE GOOD CLUSTER COULD BE FAULTY.YOU NEED A HAYNES REPAIR MANUAL.IT WILL SHOW YOU HOW TO REMOVE INSTRUMENT CLUSTER.

Mar 27, 2011 | 1998 Dodge Caravan

1 Answer

How much torque on the main nut for the rear hub on a 2000 ford focus?


Hi, The nut can be reused 4 times before renewal is required. The tightening torque is 235 Nm. If possible rotate the assembly in the opposite direction to tighten direction whilst tightening to aviod bearing damage. This applies to both disc and drum brake set up's. Hope this helps.

Jan 31, 2011 | 2000 Ford Focus

1 Answer

How to replace1997 saturn fuel pump


its not bad to do, first thing is to jack the rear of the car up and support it, next is to remove the filler neck hose from the tank, now remove the straps holding the tank but first make sure theres ajack to support tank, once straps are remove lower tank slowly until you can get to fuel lines and plug that goes to top of pump, note;fuel may spray a little when removing the fuel lines so wear safty glasses and wrap line end with a rag to aviod getting sprayed, with tank down remove retaining ring and pull pump asm, up.hope this helps.

Feb 13, 2010 | 1997 Saturn SL

1 Answer

I have a 1986 ford mustang GT. i have tried putting the H-4 conversion lights from hella. when i put the head lights on, and turn them on it seems they are drawing to much power or something, because my...


when doing this conversion you are adding extra high power lights did it recomend changing your altenator to a higher amp alt. ? this is what you will most likely have to do

Nov 20, 2009 | 1986 Ford Mustang

1 Answer

Replaced motor and trany on a 02 rendezvouz from an 04 rollover the wiring harnass on the 02 has 1 electrical plug on trany and one on the shifting stub on the trany .the 04 didnt have it so I swaped it...


did you also swap the transmission ecm from the roll over? that may be the problem,with swap like that it's best you take every thing related to the doner powerplant and trany to aviod problems

Oct 28, 2009 | 2002 Buick Rendezvous

1 Answer

Does a dodge pickup 1990 have to have emmission in Pa


Are going to move there to aviod fixing an emission issue. Of coarse most all states do

Sep 26, 2009 | 1990 Dodge Ram

1 Answer

Must i replace a 4x4 1999suburban trans with another 1999 tran?


recomend looking for a good used transmission at a junck yard that transmission should be a 4l60e

Aug 14, 2009 | 1999 GMC Suburban

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...