Question about 1990 Nissan Pulsar

Open Question

Replace car aerial - 1990 Nissan Pulsar

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will my radio new 3120 not pick up dab stations at all really tune and all I get is radio 2 have tried for a week to get magic fm thank you


If you have replaced a normal car radio with a DAB then your existing aerial is not suitable due to the required frequency range. You need a DAB aerial for cars. There are many types available, internal or external. Don't bother with converters as this will only give a marginal boost to the fm aerial.

Jun 06, 2016 | Cars & Trucks

1 Answer

How do I get my antenna off on a 1988 Nissan pulsar?


I can't find information on your model but generally a car aerial doesn't represent many problems unless it is a roof aerial sited in the centre front or rear of the roof. In this case it is usually necessary to access the underside of the aerial.
If the aerial is at the corner of the roof, retracting into a windscreen pillar, the manual versions sometimes withdraw upwards after releasing a single screw but sometimes they must be withdrawn downwards, especially if it is an electrically operated version. In this case access is usually restricted and there is limited room to withdraw the unit. Replacing this type of aerial is usually a struggle from start to finish entailing the removal of under-dash units, carpet, insulation and so forth.

Good luck!

Aug 22, 2015 | 1988 Nissan Pulsar

1 Answer

Aerial


Mast or complete aerial?

Mar 25, 2014 | Jaguar XJ6 Cars & Trucks

1 Answer

Aerial


Thought i would reply to your lonely thread. I had to replace the aerial on my last 159 as it was broken when i first got it, i replaced it with a bee sting type off0 ebay didnt cost much was worried it might be a bit rubbish but turned out to be pretty good. As far as i can remember i managed to remove the rear end of the head lining (below the aerial) by popping off the two poppers holding the headling to the roof i then managed to disconnect the cable that connects to the aerial and undo what i remember was one nut that connects to the aerial thread inside car. The job was fiddly but only because i did not want to remove the head lining any more than i had to. but not difficult. without head lining in way it really would be a two minute job.

Hope it helps
Parts Of Bmw.

May 30, 2012 | Volvo V40 Cars & Trucks

1 Answer

1998 Gen 6 Celica. Recently replaced aerial motor.


YOU COULD HAVE BLOWN A FUSE CHECK FUSE BOARD .

Oct 21, 2009 | 1998 Toyota Celica

1 Answer

How to replace a Clio aerial


got a idear for you , if you pop down to you nearest breakers most vauxhall and vw hav a short aeril on the called a bee sting aerial the simply unscrew the same as how the wip part of yor one . they should be the same thread and they look cool when changed. hope this helps

May 05, 2009 | 1986 Renault Sport

1 Answer

Kia sorento electric aerial packed up.


Look under the wheel arch and remove the plastic cowl which protects the under side of the wing.
You will see the aerial under there.
good luck

Jan 31, 2009 | Hyundai Motor 1998 Accent

1 Answer

Aerial


Normally there is a big nut on the back side of the aerial. Or possibly several smaller ones, depending on the type of aerial.
To help route the wire back to the radio, attach a string or similar to the plug before you remove the old aerial, you then pull the string through with the old wire, and can use this to pull the new wire back into place.

Alternatively, get a wire coat hanger and jam it into the stump of the broken aerial. May not be pretty, but they work reasonably well.

Sep 28, 2008 | 2005 Hyundai Accent

2 Answers

Radio am only


U NEED THE GROUND SO IT CAN WORK

Sep 17, 2008 | 1987 Nissan 300ZX

1 Answer

Fitting new antena aerial to Saab 93


Len-
The replacement only costs about $20. The dealer can also provide a replacement but it can cost upwards of $50+. Part number is 5035944.

The hardest part is removing the metal sleeve from the mast pole. Once you get this out, refit the new mast with the teeth so the motor will pull the new mast down when you turn the radio off. refit the 17mm nut on top of the mast and then turn the radio back on. It will click a few times and then be properly set.

Justin
Strictly Saab
Melbourne, FL

Jul 07, 2008 | 2000 Saab 9-3 Viggen

Not finding what you are looking for?

Open Questions:

See all 1990 Nissan Pulsar Questions

1990 Nissan Pulsar Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...