Question about 2000 Pontiac Grand Prix

1 Answer

When I accelarate the car misses looses its idle wants to cut off. spark plugs. wires, mass air flow sensor, iac new.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Maybe the Throttle position sensor or timing off.

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Kia Sorrento the only code that came on was for air flow sensor and tps but I replaced the parts and the Kia will turn on for a few seconds then turns off. I checked all sensors/fuses all good.


There is no idle relearn procedure for this vehicle. The computer will learn as the idle as the engine is running and trying to idle. If the engine still does not learn the idle and the IAC is new and the wiring from the iac to the computer is good, then chances are you might just have a bad tps, bad mass air flow sensor and or air or vacuum leak. Let me know

Nov 18, 2015 | Kia Cars & Trucks

1 Answer

Engen problem and missing


Sir, your question is not very clear, but I will still try to post a solution here. Engine missing could be due to any problem in fuel system, ignition system, engine or ECM as well.

LOW ENGINE IDLE SPEED (Poor idling):
-Throttle body (do the cleaning and idle speed learning)
-A /C signal circuit
-Fuel pump control circuit
-Fuel pump
-Intake system
-P C V valve (clogged or open) and hose

ROUGH IDLING:
-Cylinder Compression
-Ignition system (Igniters, spark plugs, wiring harness)
-Spark plug fouled, gap too wide or too short. (1.00-1.1 mm)
-Fuel injector circuit
-E C M power source circuit
-Fuel pump control circuit
-Fuel pump (required pressure 44 psi - 49 psi)
-Throttle body (cleaning)
-Intake system
-P C V valve and hose
-Air fuel ratio sensor
-Heated oxygen s ens or
-Mass air flow meter
-Idle hunting
-Throttle body
-Intake system
-P C V valve and hose
-Air fuel ratio sensor
-Mass air flow meter

HESITATION/ POOR ACCELERATION:
-Fuel pump control circuit
-Fuel pump
-Spark plug
-Ignition system
-Fuel injector circuit
-E C M power source circuit
-Mass air flow meter
-Throttle body (do cleaning)
-Intake system
-Valve timing
-Cylinder Compression


Jan 18, 2014 | 2008 Toyota Corolla

1 Answer

Car will not idle


If your car will not idle it could be a few issues.
1. Your IAC (Idle air control motor) is shot
2. You have a vacuum leak
3. fuel filter is clogged
4. you are leaking power, most likely out of spark plug wires
5. needs a tune up
6. bad gas
7. clogged injectors
8. map sensor
9. mass air flow sensor
Since you have located a rip in an intake hose, I would replace it. Depending on where it is located, and if it has wires plugged into it depends on the part. If it is black and has ridges in it, it is the mass air flow sensor. Other hose which are mostly just a generic hose and can be purchased at any auto store

Nov 09, 2013 | 1998 Buick LeSabre

1 Answer

2.2 litre 1995 gmc sonoma idles rough no trouble code. found hole i brake booster vaccum line fixed that. replaced and changed fuel filter, idle air control valve, got spark at coil packs, put new spark...


Three things you should check using a good code checker which can read sensor outputs - the throttle position sensor (TPS), the mass air flow sensor (MAF) and the EGR valve. While you are at it, replace the PCV valve.

Jul 30, 2017 | 1993 GMC Sonoma Club

2 Answers

Skips when cold and ck engine lite is on.Spark plugs have been changed. Fuel injection cleaner added to gas. Code comes up multiple missfires.any Ideas on what to do next to fix?


may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: xcardiag.com

Mar 30, 2013 | 2000 Toyota ECHO

1 Answer

1993 ford ranger 3.0


Replace map sensor

Mar 10, 2013 | Cars & Trucks

2 Answers

Engine starts and stalls


1 Inspect EGR Valve EGR Valve Sticking Open/Leaking. 2 Inspect Idle Air Control Valve IAC Valve Sticking or Faulty. 3 Inspect Mass Air Flow Sensor Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.

Jul 06, 2009 | 1987 Dodge Ramcharger

Not finding what you are looking for?
2000 Pontiac Grand Prix Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...