Question about 2005 Ford Focus

Open Question

I have a ford focus 1600 and i have broken the fuel flap hinge i have got hinge assembly and need to know to take the broken one off and the new one on can you help

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Change fuel door

You may need a combination of tools, A long nosed pliers & a screw driver, a small punch, & others. You will have to remove the bracket that holds the hinging mech on.

May 30, 2014 | 1999 Ford Mondeo

1 Answer

Ford focus mark 2 2002 1600 cc using exsessive amounts of petrol can these cars be tuned to improve this

Start with a K&N Air Filter, New Plugs, Fuel Filter and make sure your Tires are at the recommended Air Pressure

Apr 09, 2013 | Cars & Trucks

1 Answer

Trying to put fuel from a container into a ford focus 2009 model

well you could pull the lever to pull the gas tank while you have someone just gently push the back of the lid. if that don't open it then your cable to your gas tank is broken

Feb 25, 2013 | 2008 Ford Focus

1 Answer


I believe in 2003, we put a 100,000 mile Air filter assembly on the Focus to comply with California Zero emissions rule. Called PZEV. So, your filter should be a combination air filter/housing assembly that is sealed so no fuel vapors can escape. A new assmembly is over $150, so don't replace it unless you find one cheap on ebay. IF you really need one, I can get you one for 10% over cost. You can pay through Paypal.

Nov 26, 2010 | 2003 Ford Focus

1 Answer

I need to find the fuel reset button on a ford focus zx3 2002

I believe it is near the passenger's side floorboard, right behind the door hinge. There is an indentation with a rubber button and the fuel symbol near it.

Feb 22, 2010 | 2000 Ford Focus

1 Answer

My petrol flap fell off, one of the lugs on the

you can get a new hinge for the gas door at the dealership use a small punch in the center of the plastic rivet tap with a hammer the center will come out after attaching to fuel door the center of rivets are sticking out use 1/4 inch extension tap with hamer until flush and voila

Aug 06, 2009 | Volvo XC70 Cars & Trucks

1 Answer

Fuel door release will not open

  • Remove fuel tank filler cap.
  • Push back release rod - 9 - by operating remote control unlock and remove bolt - 2 -.
  • Remove rubber part - 8 - from tank filler flange and swivel out tank flap unit - 1 - from side panel - 7 -.Assembly piece - 4 - and actuator - 6 - is installed.
    • Install tank flap unit - 1 - (rubber part rolled up) with hinge side first.
    • Bolt tank flap unit - 1 - and assembly piece - 4 - with bolt - 2 -.
    Tightening torques: Bolts - 2 - 1.5 Nm
    • Remove side luggage compartment trim.
    • Disconnect harness connector at actuator - 6 -.
    • Remove actuator - 6 - using special tool Socket wrench T 10010 from angled mounting bracket.
    • Remove actuator - 6 - together with release rod - 9 - from seal - 5 - and assembly piece - 4 -.
    Installation is reverse of removal.
    Tightening torques: Bolts for actuator - 6 - 1.5 Nm .
  • May 27, 2009 | 2001 Volkswagen Passat

    Not finding what you are looking for?
    2005 Ford Focus Logo

    Related Topics:

    257 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts


    Level 3 Expert

    79077 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers


    Level 3 Expert

    5677 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides