Question about 1994 GMC Suburban

1 Answer

1994 gmc suburban will not crank even after new starter installed. Turn the key to start position, doors lock acc go on but nothing from the starter no click nothing?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 22,306 Answers

Switch on back of ignition lock broke

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn key to crank position and only once in a while.has new battery and starter ,wires on starter are good.


When the vehicle doesn't start, you will need to check the purple wire at the starter solenoid for power when the key is held in the crank position. If there is power during this procedure, the starter will be defective. If no power, possible ignition switch... neutral safety switch..starter relay ( if equipped ) or wiring problem

Mar 07, 2016 | 1995 Oldsmobile Eighty Eight

1 Answer

Installing new starter


use a test light to check for power on battery cable at starter and then power to smaller wire while someone holding in key in crank position. If you have power to both your new starter needs to be warrantied/replaced

Mar 11, 2014 | 1994 Buick LeSabre

1 Answer

Automatic door lock 1999 toyota prerunner


hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.

Jan 28, 2014 | Toyota Camry Cars & Trucks

1 Answer

Posted question couple days ago, my 2005 lincoln navigator wont start, replaced.starter and battery didnt work..when u put the key on dash board lights up but when u turn the key, nothing happens, no...


Are you certain the security has not immobilized the car? If it isn't a security issue, there is probably a problem in the start circuit.
If you check for power on the small starter solenoid wire, with the key held in crank, and no power is on that wire-the start circuit from the ignition switch to the starter solenoid has a problem. If the wire does have power with key in cranking position, probably a bad connection from battery to starter, since you have a new starter.
To be certain the engine is not locked up, put a socket and wrench on the crankshaft pulley center bolt and turn the engine over by hand a revolution or so.

Nov 27, 2013 | Cars & Trucks

1 Answer

My 1996 gmc Suburban won't turnover. Nothing. Not even a sound. Battery is good.


Go down to starter check that it is getting positive voltage to big stud. If yes, you will need to test little wire. It will get voltage when key is turned to start position. If you get voltage then & still wont start most likely starter is bad.

Jun 09, 2010 | 1996 Chevrolet Suburban

1 Answer

1999 GMC Suburban K1500 4x4 randomly will not start 3 times this week.I just had the egr valve replaced, fuel filter, rotor and cap. 5months ago had an automatic starter put on and once in a while the...


randomly will not start 3 times?????? Won't start how ? When you turn the key to start ,nothing happens or the starter engages an spins the engine but won't start an run ?

Jan 17, 2018 | 1999 GMC Suburban

1 Answer

Replaced motor in 1999 gmc suburban, 5.7l, got everything hooked back up motor will not try to crank over. have power to one leg on ignition relay and have power on both sides of crank fuse. this vehicle...


DOUBLE CHECK MAIN GROUND.IF LOOSE THIS WILL HAPPEN. ALSO CHECK FOR POWER A STARTER SOL. WHILE SOMEONE TRYS TO START VEH. IF IT IS ANTI THIEFT IT WILL STILL CRANK BE CUT OFF FUEL ARE SPARK. BUT TO TRY TO RESET, YOU ELEC LOCK ALL DOORS USING UNLOCKING BUTTON ON KEY THROB UNLOCK OR USE KEY TO UNLOCK.

Feb 15, 2010 | 1999 GMC Suburban

2 Answers

My 1996 Pontiac Sunfire wont crank...


tryy replacing the fule injectors and the fuel pump could possibly be shot as well. you have a fuel problem.

May 07, 2009 | 1996 Pontiac Sunfire

1 Answer

Wont crank or do anything.


I have 1994 for escort 1.9 5speed doing the same thing. Will not start with the key but will start if you jump the starter

Apr 26, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
1994 GMC Suburban Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...