Question about 1991 Ford Ranger Supercab

Open Question

No running lighs both turn lights come on when you put either one on trying to get a wiring diagram

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do all my lighs run all the time


For safety some manufacturers have wired the running lights to be on all of the time. Read or obtain an owners manual , for your vehicle , and see how to turn them off.

Jun 07, 2015 | Cars & Trucks

1 Answer

The lighs on the inside will not turn off


I'm not certain on your specific car, but if all the doors are closed, and the interior lamp switch is off (the dimmer for the dash lights), they should turn off. You could have a defective switch (long shot), or a short in the wiring, or the delay circuit that keeps the lights on for a time is defective. Without a diagram and some expertise in electrical circuits, this is a job for a real DIY or an auto electric shop.

Mar 28, 2014 | 2009 Lincoln MKX AWD

1 Answer

Ny brake lights work and my tail lights work .When I have the key on and the tail lights on and hit the brake pedal my passenger side lights go out ,but drivers side works


It sounds like the system is working . The problem with the pasanger side light is most likely a problem with the bulb connection or a slight ground connection to the ligh . Try cleaning the terminals to the bulb and put some dielectric grease on the contacts you might as well do them all . And also make sure the lights have a good ground connection to the body there is a ground wire for all of the lights . A bad ground or a bad bulb in the front even if the light appaers to work still has two filamants turn and running and could cause a problem in the rear lighting . Head lights will have nothing to do with this problem its the brake and siginal or running lights check it out good luck

May 16, 2011 | Nissan Maxima Cars & Trucks

1 Answer

Having trouble getting my tail lights, brake lights, turn signals lights wired. I have them all crossed up. I need a wireing diagram. 1998 Dodge Dakota Sport. Please help! ...


GO TO AUTO PARTS STORES LIKE AUTO ZONE OR ADVANCE AUTO PARTS.BUY A HAYNES REPAIR MANUAL IT WILL HAVE ALL OF YOUR ELECTRICAL LIGHING DIAGRAM.

May 03, 2011 | Dodge Dakota Cars & Trucks

1 Answer

Turn signals reverse lighs dont work need a wire diagram for this 1997 izuzu rdeo 4x4


Reverse light are operated by the range selector switch on the side of transmission aka. gear selector lever. A problem with the t/s lights would be in the turn signal combo switch.

Jan 11, 2011 | 1997 Isuzu Rodeo

1 Answer

1193 plymouth voyager. Brake lighs don't work


Maybe a relay or fuse is bad or the wiring to it.

But you said that the third brake light works.

So the brake switch must be ok.
Turn signals would be the flasher or wiring to it.prev.gif next.gif
CIRCUIT PROTECTION Fuse Block Fig. 1: The fuse box is located under a cover at the lower left instrument panel — 1987 Voyager shown 85616099.jpg
The fuse block and relay bank is located on the driver's side under the lower instrument panel. The fuse block contains fuses for various circuits as well as circuit breakers, horn relay, ignition lamp thermal time delay, and the turn signal flasher. The hazard warning flasher is mounted into a bracket below the fuse block. The individual fuse and relay locations can be found in the wiring diagrams at the end of this section.
is bad.

Aug 01, 2010 | 1993 Plymouth Voyager

1 Answer

Turn signal and emergency lights do not work


fist thing to look for is the wiring grounds, sounds like signal lights are grounding thru the running light circuit

Nov 25, 2009 | 1997 Mercury Grand Marquis

1 Answer

The wireing 2 my headlights and running lighs dont work properly the head lights bealy come on and my running lights jest dont work whats the problom and if u have the wiring code put it down plz


Hi,
How's your battery? If you need to jump your car off, looks like your alternator is going out... it's not charging your battery or supplying power to work all the electricals (The dim lights are a give-away of this problem to me).
Alternators aren't a bear to replace on your model. Just remember to disconnect the battery before you start. Good luck!

Aug 26, 2009 | 1986 Dodge Ramcharger

2 Answers

Tailer running lighs dont work


easy fix.... find the wire that goes to the LICENSE PLATE LIGHT and splice into it and run a new wire to the running light wire for the trail.. it will be very close the the Trail harness

Jan 19, 2009 | 2006 Ford F-150

1 Answer

1996 chevy caprice wiring diagram for cruse control


Are you trying to instll he cruse system in another car? BAD IDEA Are you trying to fix it in your car? first cause of fail is the third stop ligh blow

Jul 15, 2008 | 1996 Chevrolet Caprice

Not finding what you are looking for?
1991 Ford Ranger Supercab Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...