Question about 1983 Toyota Pickup

1 Answer

Toyota 22r starts hard and floods. Repalced

Toyota 22r starts hard and floods. Replaced ignition wires and cleaned choke assembly on carb

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

It sounds like the carb. float is set to high and /or the needle and seat has some dirt in it allowing to much fuel inside the carb.. This will allow to much fuel into the engine.It seems the carb could use a rebuild and dont forget to replace your fuel filter.I hope this helps.

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1984 Toyota pickup with 22R. Can't get it to star. Done changed the coil


Could be one of the following problems:
Fuel supply to carburetor:
  • Choke operating
  • Flooding
  • Needle Valve sticking
  • Vacuum Hose
  • Fuel cut solenoid not opening
  • Secondary throttle valve not closed
Ignition Problems:
  • Ignition Coil
  • Igniter
  • Distributor
Spark Plugs Faulty
Vacuum Leaks
  • PCV line
  • EGR line
  • MC line
  • Intake manifold
  • CMH
Low Compression

Aug 30, 2015 | Toyota Cars & Trucks

2 Answers

I have a 1987 toyota 4x4 pickup carb truck starts up good but if u cut it off and let it sit for 10 or 15mins .it does not wont to start till u hold the gas pedle to the floor.?? help


carb ajustment is off--issues in the float causing it to flood--cud be sticking--get a haynes manual or library sec629 has shopbooks

Jan 14, 2015 | 1987 Toyota Pickup

1 Answer

22R ENGINE RUNS BUT DIES AT IDLE


and old carb based engine
if engine has good compression, and spark is good and timed.
its a bad carb.
carbs:
1:float level good?
2; jets clean
3:all air emulsion tubes inside clear.?
4: choke set right.?

Dec 29, 2013 | 1983 Toyota Pickup

1 Answer

How do I shut down EGR system on 1986 toyota 22r 4x4 truck


I am original owner of 1986Toyota Pickup 2wd caRB. 4SP MAN. SHORT BASE MFG.IN JAPAN. I NEVER HAD ANY PROBLEMS WITH ANYTHING UNDER THE HOOD OR IDLE OR ACELLERATION. iT RUNS JUST LIKE THE DAY i BOUGHT IT IN oCT. 1986. i NEVER ADJUSTED CARB OR CHOKE OR CLEANED IT iT HAS ALL ORIGNIAL PARTS EXCEPTTHE STARTER, BATTERY AND WATER PUMP GASKET.

May 25, 2012 | Toyota Cars & Trucks

1 Answer

1988 22r pickup have to pump the gas now before starting 15 to 20 times. i didnt use to have to pump the gas before every start if it sits more than 10 hours it wont start unless i start pumping the gas...


Seems like the choke is not turning on. The 22r uses a carb if I'm not mistaken. pump it a couple of times then try pressing the pedal completely down before trying to start it. Then press the pedal half way down. the point is to set the choke when you press the pedal all the way down.

Oct 31, 2011 | 1988 Toyota Pickup

1 Answer

Real rough idle, looses power for a second when driving at speeds over 45 mph. also when accelerating from a standstill. I have replaced the sparkplugs, guaged at 0.031 ,spark plug wires, distributer...


Hi Spacey, Sounds as if you have an old model of the HiLux. Is it Carburetor or injection? If its carb I think that's where your problem will be. If there is leakage between the throttle body of the carb and the main body above it, there will be a flat spot when pulling away from start and possibly at higher revs. The easiest way of dealing with the problem is to replace the carburetor. Keep in mind that the most critical setting in any carb is the float level, if its not set correctly it will either flood or starve. Sounds as if you may have those measurements wrong. The settings are specific to the type of carb, if you need further help, tell me the type of unit fitted to your vehicle. Regards Johngee10

Jul 17, 2011 | 1987 Toyota Pickup

2 Answers

What is causing my 1986 jeep grand wagoneer engine to stall while driving? I cannot restart it but there is power. It will turn over but not start and there is gas in it. The jeep just went "poof" and died...


ok, its and old jeep, cranks but will not start.

carb fueled right? crank it wide open throttle to clean the flood
and block open the choke, if CARB has auto choke, if manual choke make sure its open. (push in knob... called choke)
fuses first. test them.
first check for spark in all cylinders.
if you have spark on all , then its flooded.
if no spark on one try a new spark plug and wire.
if all spark is dead , do the tuneup. now. all spark parts.
if spark is dead, check it at the coil, ? good there? or not.
that is a start.
if the carb is bad, we cant cover rebuilding it here.

stalls while driving has over 50 causes.
but bad spark or flooding tops list. (assumes engine is ok)

Oct 07, 2009 | 1985 Jeep Grand Wagoneer

1 Answer

Toyoat Hard to start


I recommend to remove carb and send to a specialist to have rebuilt or reconditioned. Cleaning it may not be enough. A carb that old may need to be serviced. This would be your starting point. The service shop can test it "outside" of vehicle.

Sep 09, 2009 | Toyota Cars & Trucks

1 Answer

88 Toy, 22R Carb, hard cold start


in your carburetor there is a priming passage. look in there with the air cleaner out and pump the butterfly it should squirt gas. if it doesn't then you need to open the top part of the carb and clean the hole with a hair clip. if this is not the problem it will be the choke but I'm 70 percent that this is the problem.

May 25, 2009 | 1985 Toyota Pickup

1 Answer

Toyota 22r carb leaks and floods


sounds like trash between needle valve and seat try tapping on side of float bowl, if not take off air horn ( top ) remove float clean needle valve and seat and bowl keep a eye out for trash

Mar 31, 2009 | 1984 Toyota Pickup Deluxe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

581 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...