Question about 2002 Pontiac Bonneville

1 Answer

Body Control Module for my 96 Bonneville SSEi?

Looking for a body control module for my bonneville does anyone know where i could order or get one?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 434 Answers

The BCM is a dealer or junk yard only item. When a new one is installed it must be programmed at a factory dealership

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

LOCATION OF TURN SIGNAL FLASHER 2001 BONNEVILLE


It's part of the hazard switch , electronic module !
Turn Signal/Hazard Flasher Module
In the center of the IP part of the hazard flasher switch

2001 pontiac bonneville flasher module-0gh0golvpqxksfrzlnez2sc5-2-0.jpg

Jun 06, 2017 | Cars & Trucks

1 Answer

I have a 2003 bonneville. tried to start car nothing, no click or anything. put in new starter/selinoid, battery, ignition switch. Checked all fusses which were good.


If it were a anti-theft problem the engine would crank over and start for a couple seconds then die ! PCM - engine computer disables fuel injectors , not the starter like ford PATS systems . You need to know how the starter system works before you can repair them . And replacing parts isn't the way to do it . You people on here must have money to burn . Make parts stores rich .The ignition switch is a input to the BCM - body control module or body control system , made up of Three different modules .
The body control system consists of the following 3 modules:
• The dash integration module (DIM)
• The instrument panel integration module (IPM)
• The rear integration module (RIM)
Each of the 3 body control modules integrate a number of functional systems under the control of a single module. Each of the modules are connected to the Class 2 serial data line; many control signals are implemented by Class 2 messages.
The DIM is wired to the class 2 serial data line. The various DIM input and output circuits are described in the corresponding functional areas as indicated on the DIM electrical schematics.
The DIM functions include the following:
• Control of headlights and exterior lamps
• Horn relay control
• Interior lamps incandescent dimming
• Lamps On signal with wiper/washer
• Power moding control over Class 2 serial data line
• Steering wheel controls
• Storage of the clock settings and, sending a message out on the class 2 serial data circuit in response to requests from other modules
Serial Data Power Mode
On vehicles that have several control modules connected by serial data circuits, one module is the power mode master (PMM). On this vehicle the PMM is the DIM. The PMM receives 4 signals from the ignition switch.
To determine the correct power mode the PMM uses the following circuits:
• Accessory voltage
• Ignition 1 voltage
• Ignition 3 voltage
• Off/Run/Crank voltage
Your best bet is to take your vehicle to a qualified repair shop that has the tool and the factory service repair manual .

Dec 13, 2016 | 2003 Pontiac Bonneville

1 Answer

Ponitac bonneville 2001


it sounds like the idle air control sensor or the BCM/ Body Control Module

Sep 02, 2014 | 2001 Pontiac Bonneville SSEi

2 Answers

Looking for the PCM for a 2000 pontiac bonneville. please help. irritated and hot here.


The pcm or power control module is located on the drivers side of the engine.
The pcm relay is # 4 on the power distribution box in the engine compartment.
Also in the power distribution box in location # 6 is a 10amp mini-fuse for the
power train control. good luck!

Aug 04, 2011 | 2000 Pontiac Bonneville

1 Answer

I need a new PCM computer. I have a 2001 Pontiac Bonneville SSEi. Can you tell me where the PCM is located?


Powertrain control module is inside air cleaner housing in left side of engine compartment, )

Nov 23, 2010 | 2001 Pontiac Bonneville

2 Answers

Antilock, braction, traction lights on the dash


It is none of the speed sensors.The 1214 is system contact or coil open.The 1248 is for the ebcm turned light on.These 2 are for the electronic brake control module.The 1245 is for the low tire pressure.And the 1287 is for the steering wheel position sensor.What you should do first is clear the codes and road test the vehicle.When the light comes back on check and see what codes came back.The electronic brake control module is for the antilock brakes and the traction control.When you get the codes after driving the vehicle post back with them and I can help you with whatever codes you have.Good luck.

Dec 06, 2009 | 2002 Pontiac Bonneville

2 Answers

Control arms for 2001 pontiac bonneville ssei


Try the Salvage yard, you can get then around $45.00 each if you pull the parts your self. Call around though, different Salvage Yards have different price and will always try to beat the price of another Salvage yard. They pull parts for you too if you don't fell like getting your hands dirty twice. Good luck.

Nov 16, 2009 | 2001 Pontiac Bonneville

1 Answer

2003 Bonneville SSEI


I am having the same problem and also occasionally the cruise just shuts off when I am driving on dry, straight roads. Code C1288 was cleared, but it continues to happen. I was told that the electric brake module needs to be reprogrammed and that it will cost about $80.00. They are still looking into it.

Apr 26, 2009 | 2003 Pontiac Bonneville

1 Answer

"Sticky" accelerator


no, that's not likely the throttle body. start by looking at the throttle body though, if there are cables going to it that control it, follow the cables back, one should go to the firewall, and one should go to a little black box. that box is you're cruise control unit. chances are that is what's causing the problem (try a salvage yard, they're cheaper than a dealer). however if there is an electric motor controlling the throttle, you should take the car to a shop to have it fixed.

Jan 24, 2009 | 2002 Pontiac Bonneville

Not finding what you are looking for?
2002 Pontiac Bonneville Logo

Related Topics:

326 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...