Question about 2003 Jeep Liberty

1 Answer

2002 Jeep Liberty - will not start after just turning it off.

I have the same problem. We check all everything ! Battery, fuse, wiring etc. We even went as far as replacing everything. I took it to a local repair shop and they just went back over everything we did. They reset the security mode and the truck started right up. But once again, the truck will not start after turning it off. My truck has been in the shop for a week with no luck. They said that i will have to take the truck to the dealer and have them reset the security mode because they will not release the code. Is there anyway i can go around them?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 126 Answers

The only other way around this is to have the factory installed alarm totally removed from the vehicle and that is pretty pricey

Posted on Sep 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 jeep liberty sport will not start. It won,t even turn over. drove it yesterday no problems. after 1 hour tried to start didn,t work Can you help?


Have you tried to jump started ? If your jeep starts when giving it a jump, you may have a bad battery. Check fuses for fuel and ignition systems. If your battery is bad, could be because the alternator is not charging it. Might want to have this component tested.

Nov 20, 2016 | 2002 Jeep Liberty

2 Answers

I bought a new battery and it went dead. I pulled up a trouble code that reads B1235 right rear speed sensor circuit open/shorted history current is this the reason for the battery drainage so fast?


no never ,,,think you have a faulty alternator diode ,causing the battery to drain ,,,best advice ? call a local mechanic and get them to check it out for you

Dec 03, 2015 | Cars & Trucks

1 Answer

How do i turn of the set up menu on my pioneer mosfet 50wx4 rdf ? every time i start the car et starts up in set set up menu and i have to do everyting all over again . i have had it for 3 years and i


there is two supplies to any car radio sometimes three

+12v all the time {to keep its memory}
ignition on {running}
and standby
some radios even have a backup battery you need to replace

but i think one of the perminent supplies isnt good too the radio

so check the fuses on its rear
and check its getting always 12v from the battery

check for a good ground
or any corrosion on wires etc...

Jan 10, 2015 | Mazda MAZDA3 Cars & Trucks

1 Answer

Driver side Rear Brake light doesn't light up, Back lights for entire speedometer/gas meter/RPM meter/ Temp. Gauge/ etc is out, Big PORSCHE light in back doesn't work and Right Rear Signal.


You blew the MAIN BUSS Fuse, some people call it a Fusable Link. It is the part that controls the POWER to the CAR from the Alternator/Battery.

More than likely you can not even START the car....

You have to replace the Main Bus Fuse and hopefully everything will come back on.. The Reason I say Hopefully....

You could have also Fried the Main Computer and here is where it gets Expensive.

Computers control everything, Security Features, Engine, Transmission, Radio, (starting to get the picture?)

What you did was feed 12volt Power to EVERYTHING... When you touched the wires together, you put 12Volts into the GROUND system and Everything is connected to the Ground. I mean EVERYTHING....

Hopefully your Fuse did their Job and burned up BEFORE it took out anything else...

Look for the MAIN BUS Fuse and then see what other damage has occurred...

Apr 08, 2013 | Cars & Trucks

1 Answer

Jeep just clicks when trying to start


Sounds like your starter is not working,here's a link on how to remove,take to Autozone and they will test for free,takes only a few minutes.To check for power at starter,get meter and it should read 12 volts.

Mar 22, 2013 | 2002 Jeep Liberty

1 Answer

2002 jeep liberty 3.7l overheats when i turn the heat off


your electric radiator fan not working check your fuse under the hood by your battery or a relay in the same fuse box.

Feb 24, 2013 | 2002 Jeep Liberty

1 Answer

Battery drains and idle problems when jumped. 2002 Jeep Liberty


I would look at the fuses and fuseable links, and check the output of the alternator. If you disconnect the battery you can check the battery for a dead cell, and check the major circuits for a draw with everything turned off.

Jul 25, 2012 | Jeep Liberty Cars & Trucks

Not finding what you are looking for?
2003 Jeep Liberty Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...