Question about 1991 Geo Metro

Open Question

Going to rebuild my manual tranny in 1991 metro need a shop manual

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHICH SM hose on the bottom of 91 geo metro automatic transmisson goes to the tranny to the radiator


there are 2 hoses,(pair) it's a trans cooler inside the rad.
there is no correct order. it's not polarized in any way.
its just a coil of pipe (atf cooler) inside the rad tank.
if you want it to look stock, the read the shop manual.
it covers this routing, path, and clamps if any.
even the fittings on the rad tank are same sizes, hinting
that either works, ok.

Aug 31, 2016 | 1991 Geo Metro

4 Answers

I need to know where to put the transmission oil in a 1991 Geo Metro 3 cylinder


For $20 you can get a workshop manual. This vehicle comes in a manual gearbox or an automatic gearbox. We are not able to help you until we know which?

Engine 1.0 L LP2 I3 (gasoline)
1.3 L L72 I4 (gasoline)
1.3 L LY8 I4 (gasoline) Transmission 5-speed manual
3-speed MX17 automatic

http://www.repairsurge.com/manual/Geo/Metro/1991/
Online 1991 Geo Metro Repair Manual

May 28, 2016 | Geo Cars & Trucks

1 Answer

'92 Metro ****/slips in second and high. Sometimes needs to be manually shifted


Pull the trans & rebuild it

IT SLIPS-why ask-- when it slips

That is internal wear & problems

NO FIX for slipping

Oct 08, 2014 | Cars & Trucks

1 Answer

I'm in need of schematic to rebuild a m27 getrag 284 in my sons 1991 grand prix. purchased new bearings but found a piece loose in the bottom of the tranny case. trying to find where it goes. thanks for...


There is a schematic in the Factory Repair Manual for this transmission. I repaired mine approximately 5 years ago, it was an easy thrust washer. I was able to find a tranny shop that had a used tranny for parts, because you can't buy any parts for these. I could not even cross reference the bearings.

Mar 19, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

89 Jeep Cherokee Pioneer w/AT4 auto tranny behind 4.0 engine. When cold, tranny works fine, but after 2 to 4 miles, won't engage in any gear manually or automatically, and won't engage in 4WD. After...


This sounds like all checks have been done, the oil is fine and the linkage is good, soory to say your trany is in need of a rebuild, sounds like in internal leak or weak pump, i would have a trany shop check it but i can tell you there going to say it news rebuilding. good luck.

Nov 07, 2010 | 1989 Jeep Cherokee

1 Answer

1991 Volvo 240 has problem with automatic transmission not being able to shift to higher gear. Previously, orange overdrive arrow would stick or flash, and overdrive would intermittently engage and...


What is happening is the tranny is going. They can try to replace the selenoid, but really, you need a rebuild. Whomever charged you to remove the light, probably messed things up more. Volvo's typically lose overdrive before losing all the other gears. It is time for a rebuild. Go to a reputable tranny shop who knows volvos.

Jul 31, 2010 | 1991 Volvo 240

1 Answer

Car will not go move in forward gears


You are going to need a Rebuild on this Tranny. Unless you know how to Rebuild a Tranny, I would have it done at a Tranny Shop. If you get the Clutches in the Wrong order During Rebuild it could Crack the Housing on the Tranny and cause a Bigger Problem. Please Rate My Response! Thanks!

Feb 07, 2009 | 1983 Chevrolet Camaro

1 Answer

Ignition timing for 1991 Pontiac Firefly or 1991 Chevrolet Sprint or 1991 Geo Metro


for 1991 geo metro 1.0 liter 3 cyl engine the timing is 6 degrees before top dead center. you will need a tachometer because the rpm must be 800 when you set the timing. also you will need to disconnect the vacuum advance to the distributor, and plug the hose to avoid a vacuum leak. (alternate method is to pinch the vacuum advance hose going to the distributor while you are setting the timing) Good Luck!

Oct 28, 2008 | 1991 Geo Metro

2 Answers

Dodge cummins auto transmission


hello dodge cummins owner i myself have a 98 dodge ram 1500 5.9L truck and i just recently had to rebuild my transmission. my truck would go fine in reverse but would not move in forward. when i took the trany apart i found out that the clutchs were completely gone. but in order to rebuild your trany i would sugest in getting a shop repair manual. i had purchased a shift kit for 400 dollars and it came with all the clutchs that i needed and that is much cheaper than buying a tranny or even haveing a shop work on it. the shop wanted 1500 dollars to rebuild it and to buy a new tranny it was over 2000 dollars.

Jul 31, 2008 | 1991 Dodge B Series Cargo

1 Answer

97 Metro - Downshifting


if you act like you are going to shift into first and before you do you pull back to 2nd or actually put it in first then to 2nd without the clutch. You might check your transaxle oil and also iol your shifter under the boot it can bind there.

Jun 04, 2008 | 1996 Geo Metro

Not finding what you are looking for?
1991 Geo Metro Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...