Question about 2001 Volkswagen Beetle

1 Answer

Headlight bulb replace

How to replace headlight bulb, right side, upper.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 36 Answers

^ wat is up with that being the answer? open your hood. look in there you will see the side of the headlight brackets. you will see a lever. you have to push that lever up which will release the headlight. then you pull the whole unit out from the front.Unplug the electrical connector. the remove the screw that holds the black cap on the back replace your h1 light bulb. also clean the inside where the headlight goes( hole in the car) it will make it easier to slide the unit back in. install in reverse order! FYI getting it back in s the hardest part! make sure you are aligning the rails! dont give up!

Posted on Nov 30, 2009

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: Driver side headlight bulbs burned out on 2003 VW Golf

There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in.  (I say clamps, but they're more like glorified paper clips on either side of the fixture.)  Press in on each side, pushing the clamps towards each other and pull the fixture out.

Posted on Dec 04, 2008

  • 5 Answers

SOURCE: headlight bulb replacement & side marker light bulb replacement

i think there are two flat guide pins that hold the headlight assembly in .. just pull them straight up ..and the assembly should come out ..hencse replace the bulbs.

Posted on Jan 25, 2009

  • 158 Answers

SOURCE: replacing a 1998 plymouth voyager driver side headlight bulb

If you look in the wheel well, there is a round plug that is you rotate it and remove, the headlamp is accessible through the hole.

Posted on Apr 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace headlight bulb on passenger side on 2001 mercury grand marquis?


you have to remove the whole lens usually two bolts onrad upper rad support remove grill and rmove lens unitturn on headlight mark which bulb to take out looking at other side light

Jan 14, 2011 | 2001 Mercury Grand Marquis

2 Answers

Replace headlight


Hello,
Follow the process below to replace your headlight:
  • Prop open your hood and locate the release lever for the headlight assembly, the lever is approximately 2 inches under the two upper mounting bolts that hold the fender in place.

  • Press down on the release lever and then push it back up. Pull the headlight assembly forward and slide it out of your Beetle.
  • Unplug the electrical connector from the backside of the assembly. Look toward the top part of the backside of the assembly for a black plastic tab. Push down on the tab and pull the headlight cover up and out.
  • Pull the retaining clip off of the old bulb and remove the old bulb from the assembly by pulling it straight out. Align the bulb correctly with the headlight assembly by matching the marked tabs on the bulb with the raised notches on the assembly. Set the bulb inside the assembly, pushing it down carefully.
  • Push the ends of the retaining clip into the small holes on either side of the new bulb and snap the headlight cover on to secure it.

Take care and good luck

Dec 02, 2010 | 2001 Volkswagen Beetle

2 Answers

How to remove headlight


I presume that you are replacing the bulb, typically the ENTIRE headlight with 3 or 4 bolts. NONE of which do any adjusting...then the whole thing comes out for easy bulb replacement. DO NOT TOUCH the glass of the replacement bulb.

Jun 22, 2010 | 2004 Jeep Grand Cherokee

2 Answers

Audi A4 2002 Low beams & Right front turn signal stopped working


For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram.
First fuse on first row from left upper corner is Fuse Nr.20 = F20 (15A) - RH headlamp low beam, headlamp adjustment.
First fuse on second row from left upper corner is Fuse Nr.21 = F21 (15A) - LH headlamp low beam, headlamp adjustment.

Feb 15, 2010 | 2002 Audi A4

2 Answers

How do i replace the headlights


how to replace headlight

Dec 27, 2009 | 2000 Isuzu Rodeo

1 Answer

How to replace headlight bulb


You have to remove the upper panel above the headlight that is out,to gain access to back of the headlight assembly.Unplug the burned out bulb,turn 1/4 turn either counter clockwise or clockwise depending on which side. You will feel the bulb get loose and pull straight back it should come out.

Dec 21, 2009 | 1999 Chevrolet Malibu

2 Answers

How to replace headlights bulbs in a grand cherokee 2001


  1. Remove the jack screw attaching the top of the head lamp to the head lamp mounting module.
  2. Grasp the upper inboard and lower outboard corners of the head lamp and pull the head lamp outward.
  3. Remove the bad bulb socket from the head lamp module and remove bulb from socket.
  4. Install new bulb into socket and reinstall socket into head lamp module.
  5. Position the head lamp on the vehicle and align the ball studs with the sockets.
  6. Push the head lamp inward to secure the ball studs with the sockets.
  7. Install the jack screw attaching the top of head lamp to the head lamp mounting module.
Do not touch glass of halogen bulbs at the oil can cause the headlight to blow out

Nov 12, 2009 | 2001 Jeep Grand Cherokee

2 Answers

How to replace headlights without breaking assembly.


You are supposed to remove the front bumper to take the headlight out.

However if you remove the vertical philips/10mm bolt at the far back edge of the bumper and a few of the upper 10mm bolts on the bumper cover, you can pull the bumper down far enough to access the one hidden bolt on the side of the headlight.
Just be careful you do not damage the paint when doing so.

1dc1d48.gif

Sep 12, 2009 | 2004 Toyota Celica

3 Answers

Headlight


Well according to my mitchell manuel you don't have to.here is the procedure.
1. open the hood.
2.Remove the push-pin retainer's that secure the top of the upper facia and grill assembly to the upper tie bar to allow the upper facia and grill assembly to flex forward.
3. remove ther bolt and push-pin retainer that secures the top of the headlight assembly to the upper tie bar.
4. Gently pull the upper facia and grill assembly forward to access the bolt on the inboard side of the headlight assembly
5. Pull the headlamp assembly straight out to disengage the the snap in retainer at the lower outboard back surface of the assembly. Turn the assembly so that the inboard assembly clears the front facia.
6. pull the assembly out and away from the veh.From there you'll be able to access bulbs.
be careful not to touch the bulb with fingers or oil in skin will blow bulb.
Good luck.

Aug 19, 2009 | 2004 Cadillac SRX

2 Answers

Replacing headlights


There are two clips for each light; one to each side just lift up on the clips. Then you have four upper and two lower grill clips that are the push/pull type. Just pull where the clips are located and they will pull right out. Watch for stressing the wiring going to the running lights. You then can pull the headlight grill assy out far enough to change the lights. Low beams are to the outside and high beams to the inside. DON'T TOUCH THE BULBS!!! A little twist left or right will unlock the bulbs. Use some contact grease to make sure the contacts stay good. 15 - 20 minute job.

Nov 30, 2008 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...