Question about 1996 Chevrolet Tahoe

3 Answers

Need wiring schematic 1996 chevrolet tahoe

Stop lights do not work

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1996 chevy tahoe,the radio works but i can"t get the radio stations to work,i think its a fuse but not sure what one

Posted on Mar 31, 2011

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

When i turn on heater it blows my fuel relay

Posted on Mar 27, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 532 Answers

Try a couple of things before tracing wires,first check the switch at the pedal,then the ground wires at each tail light

Posted on Sep 07, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replacing a brake light switch in a 1996 tahoe

Switch is at bottom of steering column and actuated by the brake pedal arm. Twist to unlock from holder, unplug wires, replace bad unit and reinstall.

Nov 25, 2013 | 1996 Chevrolet Tahoe

1 Answer

Plugged in a Kenwood stereo in a 2000 tahoe. Have all power but no sound. Radio is not defective. When plugging the same stereo into a 99 express van, it works just fine. My question... What is the wiring...

Hi, your factory wire colors are below. Please let me know if you have more questions.

2000 Chevrolet Tahoe Car Radio Wiring Schematic
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6 1/2? Speakersir?t=modilife-20&l=as2&o=1&a=b00009uhre
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: 6 1/2? Speakersir?t=modilife-20&l=as2&o=1&a=b00009uhre
Car Audio Rear Speakers Location: Rear Doors
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Feb 10, 2011 | 2000 Chevrolet Tahoe

1 Answer

Blowing IGN A fuse

I have the wiring diagram if you need it. Send me your email address and info on your vehicle and I will send you the diagram. Have you turned the key on and tried to jump across the starter to see if it would run?

Sep 09, 2009 | 1996 Chevrolet Tahoe

2 Answers

Daytime running lights dont work on 1996 Tahoe

Check all the fuses. Could be a bad relay for the head lights.

Aug 29, 2009 | 1997 Chevrolet Tahoe

1 Answer

When I turn on turn signals (left or right it

sounds like one of the circuit bords at taillights is bad

Aug 03, 2009 | 1996 Chevrolet Tahoe

2 Answers

95 tahoe four wheel drive stopped working/shift light not working

I have a 1996 tahoe that did the same thing to me.

There is no vacuum lines, it is all electric. The motor on the front differental is controled by the actuator switch on the top of the trans case. The motor is controled by 3 wires. 1 is a ground and the other 2 are signal wires. When the truck is in 2wd, the motor will get 12volts to ground on 1 wire all the time to turn the motor out. When you put it in 4wd, the motor will get 12 volts to ground on both signal wire to turn the motor in.

Here is the point!! Check to make sure that none of those wires from the t-case switch to the motor are shorting out on something metal. In my case those wires came out of the wire loom(black tube) and rubed the insulation off. shorting on the t-case.

If your truck ever gets stuck in 4wd, were you have to keep it in 4wd or the front end makes a hell of a noise, the actuator switch on the t-case is none to go out. cheap fix. If that ever happens and you are in a pinch. Unscrew the motor out of the front end and manualy give the motor the signals that it needs with jumper wires and the trucks battery to turn the motor out, screw the motor back in. Don't put the wires back on till you can fix it right.

Feb 07, 2009 | 1996 Chevrolet Tahoe

1 Answer


if your dash lights are not working, it could be any wire associated with the running lights. Try to find follow any wire that leads to a light that comes on with the headlights. This includes the tag lights. Check the towing lights as well.

Dec 22, 2008 | 1996 Chevrolet Tahoe

1 Answer

Electrical problem

Check your trailer plugin wires at back of veh.

Dec 01, 2008 | 1996 Chevrolet Tahoe

Not finding what you are looking for?
1996 Chevrolet Tahoe Logo

1,107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides