Question about 2003 Mazda MPV

1 Answer

There is oil in the spark pugs

There is oil in the spark plugs

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 370 Answers

If your getting oil on the plugs this is the first thing i would check...
make sure the PCV is open and not cloged, one of the resonse the you get oil in the cylinder is because crank case pressure goes up and pushes oil past the piston rings putting oil in the cylider and then to the plugs, that is where i would start for now

Posted on Sep 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put to much oil in my dodge neon 98 sport spelled on spark pugs


Take oil and put 4 quarts back into engine. After, pull your spark plugs and if not worn out clean them with a soft wire brush.

Feb 07, 2016 | Dodge Cars & Trucks

1 Answer

How do i get to the spark plugs on a 2000 saturn ls 4 door sedan


You must remove the coils that sit over each spark pug and any engine trim cover that you may have.

Aug 23, 2012 | 2000 Saturn Ls 4dr Sedan

1 Answer

1. What are the best spark pugs for a BMW 318 ti 1999 model 2.What oil is recommemded for same car


Bosch plugs are the best for the bmw's. Oil is up to how much money u want to spend. If you go with the best you have to keep using the best. I run synthic oil in my vehicles. It breaks down alot slower.

Dec 09, 2010 | BMW 318 Cars & Trucks

1 Answer

Turns over but wont start


first check fuel, then check to see if it is fireing at the spark plug. if it is fireing at plug, check to make sure it is getting fuel. ( should be able to smell fuel on the electrode end of spark pug). If it is getting fuel, and spark, you may try removeing all spark plugs, then shoot some oil into each spark plug hole. Replace plugs, and try to start. If it still wont try to start, may be out of time. Does it pop, backfire when you are cranking the engine?

Nov 08, 2010 | 2001 Hyundai Accent

1 Answer

Volvo crank sensor. Car gets spark, gass, and air but will not start. turns over but not even s sputer pop or backfire. if i ground out a pulled pug while still wired to the distibutor there is a spark ,...


If you are getting fuel air and spark to the combustion Chambers then the crank sensor is doing it's job.possible fuel washed cylinders not allowing enough internal compression to ignite the fuel.Remove about 4 plugs and squirt a little oil down in each cylinder and let sit for a moment.Turn the engine over several times with the plugs out,clean the spark plugs,re-install and see what happens.
Hope this helps your concern,
Kenneth R.

Oct 08, 2010 | 1994 Volvo 850

2 Answers

2000 ES 300: how to change oil?...


drain via sump plug,replace oil filter,fill through oil filler cap.

May 17, 2010 | 2000 Lexus ES 300

1 Answer

Subaru 2001 outback... oil under the rubber spark plug plugs,is this a problem?


Hi,
The oil in the spark pug hole is coming from a seal in the cam cover.
It will eventually fill up enough to short out the plug. Putting new seals in the cover should not be to expensive. Good Luck!!!!!!!

May 18, 2010 | 2001 Subaru Outback

1 Answer

I have a 1994 s10 blazer with4.3liter engine. it has a miss. it has new plugs, pug wires, dist cap and rotor button. when you pull off spark pug wire 2, 4 and 6 the engine has a rough miss. when you pull...


Any chance you get take that in to get the codes read. That is important and step one of the process. This will tell you the problem. If you are getting spark at the plug then more then likely you are having fuel problems.

Apr 25, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

Service question


Tools Required; J43094. Removal Procedure.turn Off the ignition swicht..Remove the ignition coil. Use theJ43094 in order to remove spark plug. Spark Plug type AC-41-965

Aug 30, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Oil leaking into sparkplug chamber


thread dammaged in head causing spark pug to come loose can fit heli coil to fix thread in head so spark plug wont come loose and leak oil into tube. other places oil can come from to cover plug in oil
remove rocker cover then remove spark plug tube they are screwed into head and clean thread of tube and apply sealant loctite to thread refit to head and may pay to replace seal for top of spark plug tube that is in rocker cover
one of these or both can leak, if tube is tight in head it may not be leaking the top seal is

Jun 04, 2009 | 1993 Isuzu Rodeo

Not finding what you are looking for?
2003 Mazda MPV Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...