Question about Mitsubishi Colt

Open Question

Mitubishi colt central locking problems not responding every time on the key sometimes it will not lock and other times it will not open when you press the key fob

Posted by on

  • Anonymous Mar 12, 2014

    wont open with fob

  • Anonymous Mar 22, 2014

    central locking will lock but will not open then sometimes it will work

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central locking on a 1.6 w reg ford focus not working and the key fab and boot open button.... front passenger side goor not locking at all all other doors i can manually lock except the front door...


(door lock actuator)all doors have one in them, they weeken, and sometimes work to open, and some times to lock, or not at all. only fix is to replace each of them as they go out, usually cost abt 20 to 40 bucks a piece

Aug 26, 2012 | 2001 Ford Focus

1 Answer

Mitsubishi colt 2005 driver door will not unlock with or without key


if the electric door lock actuator froze up this could cause the problem as it would not want to unlock either way it is inside the door panel hooked to the door latch

Jun 07, 2012 | 2005 Mitsubishi Colt 1.1

2 Answers

My Mitsubishi colt CZ1 (07 plate) has problem with cental locking. I can manually central lock but with the remote it locks/unlocks all the doors except the driver's door. Please help. Thanks


Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.

Apr 29, 2011 | 2006 Mitsubishi Colt

2 Answers

Central locking not working on drivers door rest of doors working if i open pasenger door by inside door opener


renew the drivers door lock or check if the operating solonoid is seperate from lock if so then often a good drop of engine oil down the operating arm often works

Sep 29, 2010 | 1991 Peugeot 405

1 Answer

I have a BMW316i Tourer (1992). There is a problem with the central locking. I can only lock the car via the boot or via the alarm. I am unable to open the drivers door at all and the key wont turn in it.


Try to spray some WD40 inside the lock cylinder through the key slot, sometimes when the key not in use for a long time it's getting rusted and stuck.

Aug 20, 2010 | 1992 BMW 3 Series

1 Answer

Central locking problem - will open 4 doors sometimes, then drivers dooor sometime or none


Hi, I have a Toyota Camry sportive '05 and I have a problems in central locking system . Since two days I can't locked my car with remote key . I can open by using a key ... Can pls give some ideA about the problems .

Nov 21, 2009 | 2003 Toyota Camry

1 Answer

I am having problems with the central door locking on my car , when i use the fob it locks then bounces back open again , sometimes the key locks it ok but not all the time , any ideas ?


This may be caused by a failing door solenoid. Try cycling it open/closed quickly several times with the key, if this improves it - it may be a sticky lock OR a failing solenoid, Try listening at each door in turn to see if you can hear a difference in locking noise.

hope this helps

Oct 08, 2009 | 2000 Jaguar S-Type

1 Answer

1997 Porsche Carrera S --- Central Locking System Battery went dead while on travel and now the key fob for central locking is kaput! Is there a sequence to re-sync the fob to controller?


Hi,

Maybe you can try this procedure to resyn your key.
Initialization Procedure.

1. Open central locking system using the car key.
2. Get into the car and close all doors.
3. Using the car key, switch the ignition lock briefly to position "1" and then switch off again. (Please do this switching within 5 seconds or otherwise the system is not ready for initialization.
4. At the remote control key. Press the "OPEN" key (->) and keep holding.
5. When holding the "OPEN" key, press the "LOCK" button three time.
6. After pressing the "LOCK" button 3 times, release the "OPEN" button.
7. If the initialization process is sucessful, the door will lock and unlock immediately to confirm the process.

Jun 05, 2009 | 1997 Porsche 911

3 Answers

Peugeot 307 1.6 petrol central locking problem


leave ign off with key out 3mins disconnet battery 5 mins reconnett and press lock/ unlock repeatedly until locks cycle through to re sync try this any probs come back to me

Dec 25, 2008 | 2005 Peugeot 405

2 Answers

What is the switch by handbrake picture of key inside a window


it is an anti theft device use to lock the shifter.

Dec 21, 2008 | 1998 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...