- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Not an easy task. You'll have to remove the back seat to remove the door panel. Once you have the panel off, reach in and unlock the child lock. Open the door. It gives you more room to work. Find the clip that is broken. Some of it could be in the bottom of the door. Rods are the same in diameter, but the length matters. Auto arts store are starting to carry some of them. Being a 99, junk yard is your best bet.
its in the manual
call acura and ask for help
or read the sections at alldata.com
or read the operators guide. lost in glove box. ?
there are aftermarket remote fob sold, with full docs./
in fact can go online and read there pages and docs,
all for free to read...... learn mode and all that.
Do you have a keyless entry FOB. If you do replace the battery then program the system. Unlock the doors turn the ignition key to the "ON" position then press either the lock or unlock button of the FOB turn the ignition key off.Now turn the ignition key on again and press either button on the FOB. Turn the ignition off again. Do this 3 times. This initiates programming for the power door locks. Press the lock button of each remote one at a time to be stored in memory. this must be done within 10 seconds of each remote.
3 remotes max. Turn the ignition off and remove the key to complete programming procedure. then test each remote.
I'm assuming the locks work fine with the key. If so, it sounds as if the electric lock motor is bad or the unlock wire is broken. You would have to take door panel off and check with a test light to find what the exact problem is.
here's the instructions for a 97 TL - I hope they're the same.
Note: Entering the programming mode cancels all learned keyless remotes, so none of the previously programmed remotes will work. You must reprogram all of the keyless remotes once you are in the programming mode. You must complete each step within 4 seconds of the previous step to keep the system from exiting the programming mode. You must program remotes within 10 seconds of each other 1. Turn ignition switch to ON (II) 2. Within 4 seconds press the LOCK or UNOCK button on one of the remotes. (An unprogrammed remote can be used for this step.) 3. Within 4 seconds turn ignition switch to LOCK (0) position 4. Within 4 seconds turn the ignition switch to ON (II) 5. Repeat steps 2, 3 and 4 two more times using the same keyless remote used in step 2 6. Within 4 seconds press the LOCK or UNLOCK button on the same remote. Make sure the power door locks cycle to confirm you are in programming mode. 7. Within 10 seconds press the LOCK or UNLOCK button on same remote. 8. Within 10 seconds press the LOCK or UNLOCK button on all other remotes you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote. 9. Turn the igniton switch to LOCK (0) to exit programming mode. 10. Test remote(s)