Question about 2006 Toyota RAV4

1 Answer

How to repair a fog light on a 2009 rava 4 - 2006 Toyota RAV4

Posted by on

  • henry_karen Sep 08, 2009

    Hi there It poped out of its holder it is the lt front one I see it thought the hole which held it what do I take a part to get it back in thanks Henry

  • silver top May 11, 2010

    could you please be more specific as to repair?? is it front fog light or rear ? will it not work ? or is it damaged ? if not working it more likely the bulb or feed wire fault ?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 566 Answers

Hi if you are saying the bulb ? has popped out and is now inside the lamp ? thenrather than remove lamp assy you can try this ? if bulb is still complete ie with metal body/pins attached ? use a wooden pencil with some either bluetack gum or a double side sticky pad attached one end then with a little patience you can fish it out or if you have a small pen magnet obtainable from diy stores in different sizes this is ideal i have one which extends for this job and others such as retrieving screws/bolts/nuts in unaccessable places they cost £ 1 here in uk

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I turn on fog lights on a Cadillac escalade esv 09


If it is a turn knob for lights just pull out on knob

Apr 27, 2015 | 2009 Cadillac Escalade ESV

1 Answer

2009 maxima fog lights wiring diagram


Google 2009 maxima fog lights wiring diagram and it will come right up for you.

Sep 27, 2014 | Cars & Trucks

1 Answer

Fog light diagram


hello thanks for helping others I have 2009 chevy tahoe I like to install factory fog light I now how to install fog light and headlight switch but the wiring that install in under hood junction where is gose it says x1 but i am confused

Jan 05, 2014 | 2002 Chrysler PT Cruiser

1 Answer

Where is the fog light switch located on prius 08


I'm assuming that you have the factory fog lights on a NHW20 (2004-2009) Prius. In the US 2004 Owner's Manual, it is listed in Section 2-4, "Operation of Instruments and Controls,""Lights, Wipers and Defogger,""Front Fog Lights,"

May 17, 2013 | 2008 Toyota Prius

2 Answers

RAV 4 radio, where is fuse? Is it same fuse as dome light?


When you open the fuse panel it's the lower left-hand fuse, all of the fuses are labled. It's not the same fuse as the dome light.

Jun 08, 2009 | 1997 Toyota RAV4

1 Answer

Fog lights came on; can't turn them off


1.At first take out the foglight's fuse before you battery is dead. (Fog lights stays "ON" even you leave the car).

2.You must replace the Multifunction control switch =(

Here is the photo of problem:
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/normal_sumuvalokytkin.jpg

Fog lights are connected to pin 13,14.
Fog light switch is "B". Because the current is many Amps, contact surfaces are heating up.
After that the contact opening "C" is melting (made of plastic) so the fog light stays "ON".

May 11, 2009 | 2002 Chrysler PT Cruiser

2 Answers

Fog Light


have you checked to make sure it's not just the bulb ? if it is there are likely two screws holding the lens on .... or you have to lay on your back and reach behind the light and see if you can remove the bulb that way....

Robert

Jul 17, 2008 | 2003 Mazda Protege

Not finding what you are looking for?
2006 Toyota RAV4 Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...