Question about 2002 Chrysler Town & Country

Open Question

ABS light stays on

I have a 02 Chrysler Town and Country with an active ABS fault for no pump motor voltage,fuse and relay are good

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Cant find relay or fuse for 2008 chrysler town and country front blower motor it's not marked on the fuse box


Don't worry about. Open the glove box and release it the fold down. Tabs on the side or top. The resistor is right there, replace it. don't buy a junk one, You'll be doing this every year.

Jun 28, 2016 | Chrysler Cars & Trucks

1 Answer

I have a 2000 town and country 3.3 motor, no power to starter or fuel pump. already checked fuses and relays. Any ideas???


Check for loose wire or corroded wire at starter and battery,check for power at fuse box with a test light check fuse able link or circuit breaker.

Jul 26, 2014 | 2000 Chrysler Town & Country

1 Answer

02 Town and Country Heat Controls


In the black fuse box under the hood by the battery check all fuses and use a spare relay to check the relays The fuses I would look at first are#19,20,and 24 if not it could be your BCM

Dec 12, 2011 | 2002 Chrysler Town & Country

1 Answer

The front a/c blower does not work, all fuses are good. please help


J, I am sending you some info to read but it appears that the most likely cause is the blower motor relay. Give the following notes a read and if you need some more help give me a buzz... Best of Luck..

1996 Chrysler Town & Country 3.3L, Vin R 1996 Dodge Grand Caravan ES 3.8L, Vin L 1996 Chrysler Town & Country LX 3.3L, Vin R 1996 Dodge Grand Caravan LE 3.8L, Vin L 1996 Dodge Caravan LE 3.8L, Vin L 1996 Dodge Grand Caravan SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Caravan Sport 3.3L 1996 Plymouth Grand Voyager SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Grand Caravan ES 3.3L, Vin R 1996 Plymouth Voyager Rallye 3.3L Customer Concern: Front blower does not work; no power to it. Fuse is OK. Tests/Procedures: 1. At the blower motor, there is a Dark Blue wire. This wire should have battery voltage whenever the key is in the "on" position. Power for the blower motor comes from the blower relay.

2. Access the front blower relay, it is located on the driver's side under the dash, near the junction block. There will be four wires going to it. The Dark Green wire should have battery voltage all the time. The Dark Blue wire is going to the motor. The Black/Orange wire should have battery voltage with the key in the "on" position. The Black wire should be grounded at all times. On this circuit, the relay is energized whenever the key is in the "on" position. Potential Causes: Front Blower Relay
Front Blower Relay Wiring
Heater Ventilation Air Conditioner (HVAC) Control Head
Tech Tips: The front blower relay is located under the dash, on the driver's side. It may be necessary to remove the junction block (fuse and relay box) in order to see it. Diagnostic Codes: None

Aug 28, 2011 | 1996 Chrysler Town & Country

1 Answer

2002 town & country blower motor will not


In order to achieve different speeds for the fan motor, there is a bank of resistors that reduce the voltage depending on what speed is selected. This is basicaly the same design for all cars on the road. The fail mode causes the full voltage to bypass the resistor bank so the fan runs at high speed (maybe even higher than your normal high setting). On most newer vehicles, including your '02 T&C, to help keep the resistors cool, they are mounted to a heatsink and then that assembly is mounted in a hole in the A/C ductwork just below or behind the glovebox. My '02 T&C has the 3 zone auto temp control and it had a fancier resistor block, but the function is the same. You should be able to get the cheaper one for <$25 at a parts store.

Apr 21, 2010 | 2002 Chrysler Town & Country

1 Answer

Abs & brake lites on at all times


Check the wiring to each ABS wheel sensor, more than likely the wiring is chaffed through on one of them causing the fault.

Apr 06, 2009 | 2002 Chrysler Town & Country

1 Answer

Abs light stays on


No need to untill you fix it. Bad abs senser or sencers. And you need the decoding tool to reset.

Mar 08, 2009 | 2005 Chrysler Town & Country

1 Answer

Windshield wipers dont work


Fuse # 5 in your panel should be a 20amp fuse, which provides power to wipers. Not 100% sure, but would bet there is a relay in that circuit before motor. Try to feel/hear, exactly where clicking is coming from. It is usually easy to simply narrow the click noise area down, then set finger lightly on relays, and feel it when it clicks. Pull it out & have tested or replace.

Feb 20, 2009 | 1994 Chrysler Town & Country

1 Answer

Fuel system problems


The Powertrain Control Module. I hope that this can help. Best wishes to you.

Jan 25, 2009 | 1996 Chrysler Town & Country

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

Related Topics:

420 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...