Question about 1990 Buick Reatta

Open Question

My alarm wont go off on my 1990 buick raetta, how do I correct it

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New stereo wont work


Make sure you have the correct power and ground hooked up if it comes on then but no sound from the speakers check for correct speaker wiring.

Apr 26, 2014 | 1990 Buick LeSabre

1 Answer

1990 buick reatta starting circuit problems


You could have a bad relay in the start circuit. The relay is there because of the security system. If someone tries to jump the car to steal it, the alarm will disconnect the relay and the car will not start. I believe it is in the relay box in front of the air cleaner

Apr 17, 2013 | 1990 Buick Reatta

2 Answers

Where is the ignition control module located on a 1990 buick lesabre


For 1990 Buick Lesabre 3.8L FI OHV 6cyl the Control Module-Ignition is located: Under hood, passenger side, front engine area, mounted on upper passenger side of cylinder head under ignition coil.

Hope helps (remember to rate this answer).

Apr 11, 2011 | 1990 Buick LeSabre

1 Answer

After unlocking or opening door, lights flash for 2 minutes regardless of starting vehicle with correct key


Brian,

Sounds like you have a factory, or aftermarket alarm system that was disconnected from the siren at some point. I am guessing it is aftermarket based on the fact that it will not disarm even if the correct key is used. If it is an after market alarm your problem is relatively simple to fix. Most after marke alarms are typically installed to the indicators by connecting the wires from the alarm into the cars factory fuse box. Locate the fuse box in your vehicles cabin and find look for any electrical wires that go into the fuse box from the front (WITHOUT REMOVING THE FUSE BOX). remove these wires or just the one going to your indicators, headlights, or whichever lights are flashing. The factory never connects wires to the fuse box from the front, so these wires should be obvious.

Nov 13, 2009 | 1990 Buick Reatta

1 Answer

19977 buick Lesabre limited all lights come on,wont start


factory alarms have fuses too. try looking in the fuse box... remove the fuse and it'll disable the alarm...

Jul 19, 2009 | 1997 Buick LeSabre

1 Answer

1990 z wont start/ crank over Locked key in car so used a slim jim to open Now it wont crank over


Do you still have your OEM key and alarm remote control (if equipped)? If you're sure they work, open your hood and disconnect your battery for 10 minutes, connect it again and proceed to close all doors/hood as usual, arm & desarm the alarm and proceed to open the car with your key and turn it on. Did this help??

Jun 17, 2009 | 1990 Nissan 300ZX

1 Answer

Can't find fuse Panel


Probably located in end of dash,opendrivers door panel on end of dash should pop open.

Jun 16, 2009 | 1990 Buick Century

1 Answer

I have a 1990 buick lesabre that wont start


Timing chains do not go bad on a 3800. The old 3.8 b engines did. Try a crank sensor. My timing set in my 3800 has 293500.00 miles on it.

Jan 06, 2009 | 1990 Buick LeSabre

Not finding what you are looking for?
1990 Buick Reatta Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...