Question about 1994 Ford Thunderbird

Open Question

I own a 94 thunderbird and the license plate lamps dont work replaced bulbs and fuse and they still dont work

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 chevy equinox license plate light won't work after bulb and fuse replacement


Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .

May 23, 2015 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

Need to replace fuse for license plate bulbs for 2010 Ford Edge SEL....What fuse number is it?


normally the number plate light is on the same fuse as the park lights . I would be looking for a fault in the number plate area ( broken wire or blown bulb or bad/ no earth)

Dec 06, 2013 | Nissan Quest Cars & Trucks

1 Answer

How to replace License Plate Bulb '96 Jeep Grand Cherokee Limited


Hi Timmy:

Check this procedure from Repair manual...


LICENSE PLATE LAMP - REMOVAL
(1) Remove screws and license plate lamp visor from liftgate (Fig. 10).
(2) Remove bulb from lamp socket.

INSTALLATION
(1) Install a bulb in lamp socket.
(2) Position license plate lamp visor on liftgate and install screws (Fig 10).


4_28_2012_5_22_57_pm.jpg


Hope this helps.

Apr 28, 2012 | 1996 Jeep Grand Cherokee

1 Answer

I cant find my fuse for the license plate lamps. I was in an accident and one of them got smashed and the other is not lighting either. Im thinking its a fuse problem but there is no fuse dedicated to the...


hi.
most cars run licence plate lamps on the same fuse as the tail lights.
if your tail lights work, then it is more likely to be a fault on the bulbs or bulb holders, or the wiring in that area, probably caused by the crash.

i would recheck this area first, using new bulbs to rule these out.

May 13, 2011 | Nissan Xterra Cars & Trucks

1 Answer

Tag light is not working. is there a fuse that will get the light turned back on?


The fuse labeled REAR PARK LP 15A in the right instrument panel fuse box powers the rear park lamps, and the tag lamps. If your rear park lamps are working then you most likely need to replace the tag lamps (bulbs). Use the following procedure to replace the lamps.

To Remove:
  1. Remove the two mounting screws from the license plate lamp.
  2. Remove the license plate lamp from the rear bumper fascia.
  3. Remove the license plate lamp socket by turning it counterclockwise.
To Install:
  1. Install the license plate lamp socket by turning it clockwise.
  2. Position the license plate lamp to the rear bumper fascia.
  3. Install the license plate lamp mounting screws.

Feb 17, 2011 | 2004 Chevrolet Impala

1 Answer

License plate lamp doesn't work after replacing


Have you checked for power at the socket? But most vehicles do have 2-3 fuse panels; in different locations.

Jan 26, 2010 | 2005 Chrysler Pacifica

1 Answer

2007 Pontiac G6. Rear license plate bulb socket dead


park lamp and license plate share same fuse.check park lamp fuse.if fuse good you have ground wire problems.

Nov 30, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

1999 Dodge Neon rear license Plate bulb


LICENSE PLATE LAMP BULB
REMOVAL
  1. Remove screws attaching license plate lamp to rear bumper
  2. Remove lamp from bumper.
  3. Remove bulb socket from lamp.
  4. Pull bulb from socket.

INSTALLATION
  1. Install bulb into socket.
  2. Install bulb socket into lamp.
  3. Place lamp in position.
  4. Install screws attaching license plate lamp to rear bumper.

Oct 08, 2009 | 1999 Dodge Neon

2 Answers

My brake lights work but the tail lights and license plate light don't work every time I turn on the fuse it blows I have a 1984 pontiac fiero.


Remove all bulbs on the tail lights and license plate circuit.
Replace fuse, turn on parking lamps- check if fuse blows without any lamps connected.
If it does, check for short circuit to ground on the taillight/license plate wiring.

If it doesn't blow, re-install one lamp at a time until all lights work. you may have a faulty lamp or lampsocket.

Jul 07, 2009 | 1985 Pontiac Fiero

Not finding what you are looking for?
1994 Ford Thunderbird Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...