Question about 2001 Chevrolet Impala

1 Answer

I need to know where the a/c low pressure switch is on a 2001 impala

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 4,340 Answers

Typically you will find this control near the receiver/dryer. DO not override it, as correct pressure is required for the system to LUBRICATE, and if pressure is not appropriate, lube will not flow correctly and system will self destruct, meaning big bills rather than realtively small repair that caused this condition.

Posted on Sep 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can't turn off low pressure sign


Disconnect your battery and let sit for 10 minutes. only have to take one cable off battery. Replace cable after 10 minutes. Codes should reset.

Jan 25, 2013 | 2001 Chevrolet Impala

1 Answer

On an ac system how do i check the high & low preasure switches and what do these switches operate and what is the purpose of them?


If your 2003 Impala had a low pressure switch it would shut off the compressor if the low side pressure got to low. This would indicate that there is not enough refrigerant in the system an therefore not enough oil flow through the compressor so the compressor is shut down.

The high pressure switch, if your impala had one, would turn on the fan once the a/c pressure on the high side reached a certain pressure.

Switches are just that, they are either on or off. A low pressure is normally on and a high pressure is normally off (this can vary greatly depending on the car).

Your impala uses a pressure sensor. The sensor reports actual pressure data to the PCM which combines info from other sensor to determine what should be turned on and when.

Hope that helps. If you have any questions let me know and I'll see if I can answer them for you.

Oct 09, 2011 | 2003 Chevrolet Impala

1 Answer

How do i get rid of the low tire pressure light on a 2001 chevy impala 3.6liter 6cyl?


Put air in whichever tire is low and the light should go off. Use a manual tire pressure gauge to find out which tire needs the air.

Jul 05, 2011 | 2004 Chevrolet Impala

1 Answer

Compressor will not engage on 2001 Impala? Where is low pressure switch located on 2001 Impala


It is located by the accumulator or dryer , a long canister shaped part, that will

have a pressure switch attached to it, and a two wire molex, if there is freon pressure

in the cannistor, the switch will close and send voltage to engage the clutch on

the compressor, if there is no voltage there the clutch will not work and you may

have a blown fuse or bad switch on your dashboard. i would check for voltage

at the pressure switch 1st, if its there, pull the molex off , jump it out and see if

the clutch engages. if you have power and you jump out the molex and the

clutch does not engage, you could have a bad clutch or bad compressor.

if it does engage, just replace the pressure switch, if you do replace it, make

sure to lube the seal with pag oil. good luck!

Jun 28, 2011 | 2001 Chevrolet Impala

1 Answer

How do I reset the low tire pressure light in a 2001 Chevy impala


Hello
Your going to need to look at the placard in the drivers side door for recomennded air pressure.

Then put in the exact amount.You may need to drive 5 or 10 miles before it goes out.

Mar 11, 2011 | 2001 Chevrolet Impala

1 Answer

Low oil pressure light is on.\r\n01 chevy impala. just changed oil and filter.


the first thing is to make sure oil is full and not leaking, next check that correct oil and filter was installed, then if all is good then try replacing the oil preasure switch,

Jun 21, 2010 | 2001 Chevrolet Impala

1 Answer

Compressor dont come on


Easy solution. Your out of refrigerant. When the "Freon" level drops to low, the low pressure trips a switch to kill power to the compressor. Evac, Recharge (w/Dye), try again.

May 30, 2010 | 2001 Chevrolet Impala

1 Answer

I want to reset the low tire pressure light from my 2001 chevy impala. I go into the stereo disp. Button but the option is not in there how can I reset it without using the stereo?


I want to reset the low tire pressure light on my 2003 chevy impala. I go into the stereo disp. button, but the option is not there. How can reset it without using the stereo?

May 20, 2010 | Cars & Trucks

2 Answers

Need to find Low Pressure A?C Port 2001 Impala 3.8


The low pressure port is against the fire wall, look straight back and you will see it.
Greg

May 31, 2009 | 2001 Chevrolet Impala

Not finding what you are looking for?
2001 Chevrolet Impala Logo

Related Topics:

400 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...