Question about Toyota Corolla

Open Question

'96 corolla idle speed is too high - Corolla Toyota Cars & Trucks

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: 1988 Toyota Corolla high idle with lights on

Because it's carbeurated they have an electric 'idle up' solinoid (or vacuume) to compensate for rev loss when load is put on the engine caused by the alternator working harder because your using power. It should have a small adjustment screw on the carbeurator to lower the revs. If you have it set too low it will shudder when in drive & foot on brake with headlights on. It should only pick up about 200rpm when lights are on. To find the screw, take the air filter off, run the engine & look for something moving when the lights are turned on & off. Somewhere near the moving bit you will find the adjustment screw. I hope. I'm not sure exactly where it is on that model.

Posted on Apr 10, 2009

Ad
  • 318 Answers

SOURCE: Hi idle speed for a toyota Corolla 2001

The idle is not adjustable. Look for a disconnected hose or something elde loose under the hood. an intake leak is posible.

Posted on Jun 07, 2009

  • 43 Answers

SOURCE: My car is 96, it

There is a small phillips head screw if you trace the throttle cable out from the firewall to the driver side of the engine where it meets the throttle body. turning the screw clockwise with lower the engine idle speed while counterclockwise will raise it.

You will see the throttle body come to rest on the screw, the more its spins tight to rest the higher the idle is going to be and vice versa

Posted on Apr 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stop idling speed


By default it is OK and acceptable.

Mar 28, 2014 | 2005 Toyota Corolla

1 Answer

2008 Corolla that has a rattle noise in the engine compartment


I would check exhaust system for loose heat shields or bracket.

Jul 02, 2012 | 2008 Toyota Corolla

1 Answer

MY IS IDOLING VERY FAST NEED TO USE BOTH FEET TO KEEP CAR FROM MOVING FORWARD FAST


IF YOU HAVE CARBURETOR. IDLE SPEED TOO HIGH NEED ADJUSTING. CHECK ACCELERATOR LINKAGE OR CABLE COULD BE IN A BIND CAUSING HIGH IDLE SPEED.MAKE SURE THE ACCELERATOR PEDAL FLOOR MAT NOT IN THE WAY.CHECK CARBURETOR MOUNTING BOLTS.RETIGHTEN TO MAKE YOU DONT HAVE A VACUUM LEAK BETWEEN CARBURETOR GASKET AND INTAKE MANIFOLD THAT WILL CAUSE HIGH IDLE SPEED.IF YOU HAVE FUEL INJECTION ENGINE LET A GARAGE SET THE TIMING AND IDLE.

Nov 22, 2010 | 1988 Toyota Corolla 4 Door

1 Answer

Idling problem toyota altis


Either there is a vacuum leak causing the high idle, or
the IACV is bad or being controlled by the computer to make idle speed too high:

To change the IACV refer to the following:
Idle Speed Control (Idle Air Control) Valve Removal & Installation To Remove:
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove the throttle body. Idle speed control valve toy_cor-04-18-1187.gif

  3. Remove the 3 mounting screws from the throttle body. Remove the idle speed control valve and gasket.
To Install:
  1. Using a new gasket install the idle speed control valve on the throttle body with the 3 mounting screws.
    • Tighten 33 inch lbs. (3.7 Nm).
  2. Install the throttle body.
prev.gif next.gif

Jul 16, 2010 | 2004 Toyota Corolla

2 Answers

'03 Toyota Corolla 1,4 VVT-i 4ZZ engine idle rpm


Idle is factory set and cannot be adjusted, your best bet is checking for cracked hose pipework for air intake at idle,(not at problem under exceleration and driving) Any slight upset to the air /fuel ratio will be most prevelent at idle speeds.Check hoses where the meet metal flanges on manifold intakes and any sharp bends in ppipes.Good luck

Apr 05, 2010 | 2003 Toyota Corolla

1 Answer

Hi idle speed for a toyota Corolla 2001


The idle is not adjustable. Look for a disconnected hose or something elde loose under the hood. an intake leak is posible.

Jun 01, 2009 | 2001 Toyota Corolla

1 Answer

Corolla Having trouble shifting


This could be a kick-down servo adjustment.

Refer to the service manual.

Frank
Frank's Friendly Cars Maui Car Rental

www.MauiCarRental.biz

May 17, 2009 | 1996 Toyota Corolla

2 Answers

Idles to high


You may need an Idle Air Control Valve (a common problem), I would also change the thermostat as well. If its reading cold it will cause the car to idle high.

Apr 13, 2009 | Toyota Camry Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...