Question about 2000 Audi A6

Open Question

Behind the feul lid in the boot compartment is a black plastic box, which is making a drum like noise

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do a 2005 kia sorento LX have a air cabin filter? If so, where is it located at? Checked glove compartment and I do not see it.


Try first looking beneath and behind the glove box with a mirror, if no see, then release glove box limiters each side, lower glove box to look behind, not usually necessary to totally remove glove box. The cover is black plastic on black plastic, so bright LED flashlight helpful. Look for strip of black plastic about 1.5 inch wide by 6 inch long. Feel for release tangs either end of the cover, releasing one and it should pop off and then see usually which cardboard edge of filter. Take old filter to auto parts store and make sure new filter is a match.

Sep 20, 2015 | Kia Cars & Trucks

1 Answer

Where is the fuse located for the inside lights


Look for s large square box with a plastic lid with FUSE written on it within the Engine compartment .
Alternatively probably underneath the footwell area or behind a footwell panel normally on other cars.

Mar 07, 2015 | 2001 Mercury Villager

1 Answer

Show location feul relay


Its in the engine compartment in a black covered box on the driver side near the brake master cylinder. The lid pops off and there are several relays and fuses. Their placement is on the lid. To test the fuel pump you can pull the horn relay and use it as a test.

Apr 28, 2014 | 1987 Ford Bronco

2 Answers

Bentley Boot lid manual release


This is all the Bentley shows:

doorlockswitch1.gif
Location: Driver's side door trim in storage compartment.

Removing:

- Remove driver's side door trim:
Repair Manual, Body Interior, Repair Group 70 - Unplug connectors.


doorlockswitch2.gif
Carefully disengage catches -arrows-.
- Press switch for interior monitoring and towing protection -1- or trunk release switch -2- out of trim toward rear.

Installing

Installation is carried out in the reverse order.


doorlockswitch3.gif
Remove trunk lid lock.

Repair Manual, Body Exterior, Repair Group 55
- Use a flat screwdriver to pry plastic tab -3- off retaining pins -1-.
- Bend plastic tab fully to rear.
- Pull contact switch -2- first sideways and then up and out of trunk lid lock.

Installing

Install in reverse order, paying attention to the following:

Note:

Make sure that washers are correctly seated between plastic tab and trunk lid lock.

Sep 01, 2012 | Bentley Continental Flying Spur Cars &...

1 Answer

Where is the fuse box in a BMW z3 1998


black plastic fuse box in the engine compartment on the left side of the car close to the firewall. The fuse is 30 Amp; it is fuse number 32 (the location diagram is on the inside of the lid on the fuse box).

Jan 20, 2012 | 1998 BMW Z3 Roadster

1 Answer

Where is the relay switch for 2004 olds alero


Not sure which relay you are looking for, but most relays are in the Power Distribution box in the engine compartment. This is a black plastic box with a removable lid. The underside of the lid will give a location for each relay circuit and also fuse locations for a variety of other circuits.

Feb 12, 2011 | 2004 Oldsmobile Alero

2 Answers

Where can i find the fuse on my 2003 chevy silverado z-71?


Some fuses are on the drivers end of the dash board; behind a cover that is accessible when your drivers door is open. Just pop the plastic cover off and there they are. There is also a little white tool to help pull the fuses out (it should be snapped inside this cover).

Also. under the hood there is a black square compartment with a snap on plastic lid (also on the drivers side of the vehicle). This box has many of the relays inside along with many of your fuses.

I think there may be some down by the parking brake pedal too, I am not sure what all is behind that cover, but it has a plastic nut that you can just turn off and remove the cover. Sorry if it does not have fuses behind it. It's been a while since I looked in that one.

Good Luck!

Feb 05, 2011 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

How to replace cabin air filter in 2003 pilot


Step 1 Take everything out of the glove box on the passenger side. Squeeze the black clips on either side of the glove box interior to free it from its retainer and pull it toward you. It will glide forward on hinged arms. Lower it as much as possible so it's out of your way.
  • Step 2 Identify the gray plastic bar that runs from left to right across the bottom of the glove box opening. This is a piece of plastic molded to the rest of the glove box assembly, but it covers up a removable bar that is mounted directly in front of the cabin air filtermag-glass_10x10.gif case. You'll have to cut this plastic bar off with a razor knife to proceed. Fortunately, this isn't too difficult; just cut carefully and steadily, and make your cuts as close as possible to the ends of the bar.
  • Step 3 Remove the metal bar you uncovered in the previous step. It is screwed into the glove box assembly with Phillips head screws on either side.
  • Step 4 Open the cabin air filter case, which is the large plastic case on the left side off the glove box opening. The hatch will come all the way off when you open it.
  • Step 5 Take the old air filter out of the case and throw it away.
  • Step 6 Look at the arrows on the filter and the arrows on the filter case that indicate the direction of the air flow. Slide the new filter into place so that the arrows are both pointing the same way.
  • Step 7 Put the lid back on the air filter case and reinstall the metal bar you removed in Step 3.
  • Step 8 Push the glove box interior compartment back into place and listen for the snapping sound. Put the glove box contents back, close the lid and you're done.
  • Dec 06, 2009 | 2003 Honda Pilot

    2 Answers

    Where nad how to check cabin air fielter?


    The Cabin air filter is located behind the glove box, There is a plastic cover that must be removed to change the filter, if the filter has never been changed a plastic bracket may have to be removed also.

    Sep 22, 2009 | 2006 Honda Odyssey

    Not finding what you are looking for?
    2000 Audi A6 Logo

    Related Topics:

    33 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Audi Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    yadayada
    yadayada

    Level 3 Expert

    75235 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    14251 Answers

    Are you an Audi Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...