Question about 2006 Ford Fusion

1 Answer

No faster than....

The check engine light blinks 8 times and the little wrench looking light is on and the car acts like the gas is not getting to the engine. Will go no faster than 55 mph.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Expert
  • 205 Answers

Take it to a computer diagnose center. Now a days most garages do that. Find the right cause for this misshappen's.

Posted on Sep 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 2004 chevy impala with a 3.8 engine acts like it dont want to go the rpms are kinda high my check engune light is on and blinking and i smell gas but my car is reading an o2 sensor code

Almost sounds like something is clogged up possibly catalytic converter.. Take to a well known shop for further testing, I would not drive it with blinking engine light just my thought.
Good luck.

Jun 18, 2015 | 2004 Chevrolet Impala

1 Answer

Wrench light came on and lost all throttle truck hesitating acting like bad gas turn off fires back up and acts fine only seems to act up when driving a little aggressive

Your vehicle explained it all to you. Take the vehicle in for maintenance. Your car is cutting engine power until your problem is repaired.

Oct 20, 2013 | 2010 Ford Escape XLT

1 Answer

2005cts 3.6 engin light on the gas it gets engin light blinks

the light blinks to let you know that the engine is misfiring and dumping raw fuel in to the catalytic converter . It will burn up the catalytic converter if the problem is not corrected leading to a much higher repair bill

Jan 29, 2013 | 2005 Cadillac CTS

1 Answer

I have a 2007 ford fusion and its idle by its self my wrench light came on and then went off. its sound like its missing. i know i need and oil change it acts like it dnt wanna take da gas. my check engine...

Normally when the wrench light comes on it relates to the electronic throttle body. When the computer detects a fault with the throttle body it will go into a fail safe mode and limit throttle inputs.
You should get your oil changes on time but I dont think this is your problem. You really need to get the vehicle codes read by the dealer or some auto parts stores read the computer codes for free.

Sep 15, 2011 | Ford Fusion Cars & Trucks

1 Answer

My 1995 Mercedes 420E bucks like if it is running out of gas!! but the engine never stop running. I have put it in shop 3 time now!!! I get the same answer very time if the check engine light don't come on...

Sounds as if the engine control module has gone bad. Here's the funny part if the engine control module is faulty it will never know its faulty so it may never turn on the check engine light. The throttle actuator and the air flow meter can also cause driveability problems with the M119 engine. You should be able to pull blink codes from the 8 or 12 pin connector next to the battery. pull the little cover off the connector that sits on the firewall. With the key in position 2 and the engine not running push the little button in for 3 seconds and watch and count how many times it flashes. If it flashes only once then that means no faults. If it flashes more than once then count the blinks and repeat holding for 3 seconds to see if there's more then one codes. This is checking the codes of the DM (diagnostic module) it should have a code if the engine control module is faulty. All this is assuming that all the initial step have been taken like checking distributor cap,rotor,plugs,wires and vacuum leaks.

Oct 11, 2010 | 1995 Mercedes-Benz E-Class

2 Answers

A light came on in the dashboard in the form of a wrench, what does it mean? While the light was on the car would not go any faster than 20MPH.

get it to a mechanic asap
that is a check engine light-if your vehicle is experiencing these problems while the light is on that could mean a potential breakdown that could leave you stranded

Aug 18, 2010 | 2005 Ford Five Hundred

1 Answer

Have a 2002 Tribute (purchased new). Just bought gas, car idles rough...engine check light is lit (not blinking). Is this a definite sign of water in gas? Didn't use car for two days since snowstorm in our...

Not necessarily so, It may be the timing "Chain" it may also be a fuel system problem, or ignition system.

If the Check engine light is lit then I would Highly suggest checking what the issue is. Especially if the vehicle is acting in an odd way. you can get this done free at Autozone stores if the individual store offers it..

Dec 27, 2009 | 2002 Mazda Tribute

3 Answers

Timing belt failure? 1997 chevy s10 2.2L 4 cyl.

hi bob, take off the oil filler cap, have someone crank the engine while you look inside, if the rockers are not moving, it is a broken or slipped belt, if the rockers are moving try a compression test to see if the problem is limited to one cylinder or all of them....does the sound of the engine cranking seem faster than normal? is there any noise (clanking/banging) while cranking? marty good luck let me know!

Jun 07, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

Car stalls if the RPMs fall under 1000

is car running on all cylinders pull plugs and check condition

Dec 13, 2008 | 2000 Hyundai Accent

Not finding what you are looking for?

Open Questions:

See all 2006 Ford Fusion Questions

2006 Ford Fusion Logo

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides