Question about 1991 Mazda RX-7

Open Question

Start perfect & right after second gear the check engine light on

1991 Rx7 start like brand new. Once shift 1 gear and try it hard to shift the second gear the check engine comes on and the car start misfiring and loss of power. If I reset the Ignition car is ok if I drive under 3000 rpm.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes I/P lights to blink when put in gear?


2005 Chrysler 300 2.7l Throttle Body Control Warning Light ...

www.cargurus.com > Questions > Chrysler > 300

CarGurusAug 7, 2014 - 2005 Chrysler 300 2.7L throttle body Control warning light or "RED ...bolt starts flashing and the car gets stuck in limp mode or second gear.Missing: p

PCM/TCM Software Updates Will Address Shifting Problems ...

repairpal.com > Problems > Chrysler > 300
Chrysler 300 PCM/TCM Software Updates Will Address Shifting Problems. ... If you experience rough shift and/or shuddering during gear shifting, software ... Car would not go over 20 mph and check engine light along with ABS/BAP light ... Once he put the new battery in the car ran fine for a while and the problems all cam ...Missing: p

ECM with bad connection, causing engine to stall - 2005 ...

? 1:08
https://www.youtube.com/watch?v=IgLe0t5may8
Oct 23, 2011 - Uploaded by SignedOnAsJoe
Check NHTSA chrysler extended the warranty on fuel tanks. ...Any one knows how can I put a used ecm in my 2005 300 do I need to buy new ... How to view fault codes Chyrsler 300 HTWL - Duration: 1:22. by Leo P 28,908 views ... Rough Run, Stumble or Stall, Check Engine Light-How To Check Vehicle ...Missing: blink

Dec 19, 2015 | 2005 Chrysler 300 Touring

1 Answer

91 honda accord with blinking S light


tune the engine...bad jgnition parts can cause the trans to shift improprerly...my 4 cyl. camry was not going into 1st gear or studdering on first.. corrected with tune-up and cleaned egr valve.. found a lot of carbon in intake manifold.. also replaced canister purge from tank to intake...still need to correct carbon ...but car shifts perfectly.!!!

May 22, 2013 | 1991 Honda Accord

1 Answer

Manual shift light blinks, chugs when accelerating.


Hi Seth, Check out your engine and gear box mountings! Regards John

Apr 01, 2012 | 1990 Ford Probe

1 Answer

Hello all. i have a toyota carina ti 1.5L, 96 model. 5AFE engine with AT. from last 10 days, suddenly my gear is giving problem. i am shifting gear from parking to drive, it is taking like 2 seconds to...


No you are looking for expensive solutions which it may not need ---start engine and make sure handbrake is on hard then select reverse and check the fluid level with the engine running ,i think you will find its about just under a litre short of transmission fluid but you cannot check it properly unless its in reverse with engine running ,and for good measure put a brick behind the drive wheels .

Feb 03, 2011 | 1995 Toyota Corolla

1 Answer

91 camaro won't start 3.1 6V. Changed fuel pump, injectors, & ICM, has spark & will start with starting fluid, then die. But will not start and run. It cranks over, but won't catch. Security light...


Is the fuel filter ok? - fuel pump ok? Sometimes a new fuel pump is faulty. You may need to check your fuel pressure. Could even be a plugged fuel return line. PS be careful using starter fluid - it can be hard on an engine. Le t m e know. Thanks

Dec 22, 2010 | 1991 Chevrolet Camaro

3 Answers

After 20 miles of driving it shifts late and hard from 1st to 2nd


many things can cuase this, the first thing to do is have the computer scaned, there should be codes it there, these codes will give a general idea of the problem. you should also check the trany fluid level,(engine warm,in park, level ground). there may be a few things to check, the distributor cap and rotor, also the wires. you may have weak fuel preasure,or even a bad module, so start by having the codes pulled and will go from there,also it doesnt start now,check the fuel preasure and also check for spark at the plugs.

Mar 14, 2010 | 1991 Oldsmobile Custom Cruiser

1 Answer

How to reset the service engine soon light


If there is an Auto Zone or any other large auto parts store, have them scan the truck for the DTC codes. The DTC codes will identify the Issues that needs to be addressed in your engine and transmission that has set off the service engine light on. Once the issues has been resolved, the light will reset it self after the third start up and after 40 start up will erase it self from the history as long as there is no additional issues. Good luck and hope this helps, Shift suddenly become very hard. When going from park to either reverse or drive it slams into gear. 1-2 and 2-3 shifts are also harsh. All gears seems to work. Problem may be intermittent: Check TPS for smooth electrical response. If the response is jumpy or erratic at all, replace TPS.

Nov 11, 2009 | 1997 GMC Sierra

2 Answers

1991 3.3L Plymouth Voyager, Transmission temp sticks in first.


John, this sounds like a valve hanging up in the valve body. The car shifts when the govenor pressure overcomes throttle valve pressure in this valve body.

What is the condition of the fluid? Is it at all dark or grey, does it smell burnt? It should be a nice light pink. If not, have the fluild and filter for the trans changed. This may take care of the problem.

If the oil is really burnt, you are at the end of the life of the clutches and you are looking at a complete trans rebuild. If the oil is ok, a trans shop should be able to take just the valve body down, clean it and eliminate the problem without overhauling the entire transmission

good luck

Feb 09, 2009 | 1991 Plymouth Voyager

3 Answers

Dodge Durango Transmission Problem


Code 0753 means Transmission 3-4 shift solenoid or transmission relay circuit problem. The PCM (engine computer) is seeing an incorrect input electrically for the gear or speed it should be seeing. You will need to find a qualified transmission shop to diagnose the problem. Possible causes for the trouble code start with worn/dirty fluid, electrical repairs & transmission overhaul.

Feb 04, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
1991 Mazda RX-7 Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...