Question about 2000 Ford F150 Flareside SuperCab

1 Answer

How to wire a starter on a 2000 ford f-150 - 2000 Ford F150 Flareside SuperCab

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 636 Answers

Very fool proof procedure, the wires are all different sizes so just pay attention, if the connector feels sloppy than it doesn't belong, all connections should be tight . Make sure that you disconnect your battery before installation.

Posted on Sep 07, 2009

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

harley9701ha
  • 424 Answers

SOURCE: 95 ford f-150 wont start. starter relay not wired

All the wires except the small red one from the starter go on the left side of the solenoid. Put the small red wire on the right side of the solenoid.Good luck.

Posted on Feb 24, 2010

  • 834 Answers

SOURCE: need wiring diagram for a 1997 ford f 150 p/u 4wd

The field wire to the starter has a small eyelet connector that connects to the small terminal on the starter solenoid (sometimes marked "S").

All other wires have a large eyelet connector and they are all connected together with the battery cable to the large terminal on the starter solenoid (sometimes marked "BAT").

Sometimes the field wire to the starter is a push on type connector, and there would only be one obvious terminal on the starter solenoid that it could be connected to.

Posted on May 02, 2010

  • 1 Answer

SOURCE: 1984 ford f-150 4x4 ignition wiring diagram i need...

when looking at it from the front the most left is from the battery, now going right from there the little pin is from ignition, basically to flip this giant switch on. next little pin goes to your fuel shut off relay, it will turn on that relay to send power to your pump while cranking, next is the large out. far right. that goes to your starter.

Posted on Jan 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter stays engaged. why?


The return spring on the bendix has broken or the helix is so dirty, that the bendix is stuck.

Jan 27, 2016 | 2003 Ford F-150

1 Answer

My 2005 Ford F-150 truck won't crank and is making a clicking noise when the key is turned over, what's wrong?


if the click noise is on the starter is bad . but if is on the selenoid the selenoid is bad but first clean all battery terminals use a wire brush the wire on the starter too auto zone can check the starter free

Dec 15, 2010 | 2005 Ford F-150

1 Answer

My 1988 ford F 150 when i start it the truck starts but the starter grinds like the bendicks is not disengaging the starter is good. It is like the ignition is still telling the starter to start. I think...


I guess what your doing is disconnecting the battery to stop the starter from grinding, on the starter solenoid sit on the fire wall there a small wire that just plug's into the solenoid that wire come's from the ignition switch, disconnect it connect battery if starter till stays engage it's not the switch it's the starter, also try checking voltage at that small wire should only have voltage with key to start only, also try hitting the starter some time that will disengage it, but more then likely bad starter, good luck, hope this was very helpful.

May 21, 2010 | 1988 Ford F 150

1 Answer

Need wiring diagram for a 1997 ford f 150 p/u 4wd


The field wire to the starter has a small eyelet connector that connects to the small terminal on the starter solenoid (sometimes marked "S").

All other wires have a large eyelet connector and they are all connected together with the battery cable to the large terminal on the starter solenoid (sometimes marked "BAT").

Sometimes the field wire to the starter is a push on type connector, and there would only be one obvious terminal on the starter solenoid that it could be connected to.

May 02, 2010 | 1997 Ford F150 Regular Cab

1 Answer

2000 f-150 wont start all i hear is a starter click when i turn the key i replaced the starter and secondary selinoid


Dirty or loose connections from the battery to starter or a bad starter solenoid

Apr 29, 2010 | 2004 Ford F150

1 Answer

95 ford f-150 wont start. starter relay not wired right. how do you wire it?


All the wires except the small red one from the starter go on the left side of the solenoid. Put the small red wire on the right side of the solenoid.Good luck.

Feb 24, 2010 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
2000 Ford F150 Flareside SuperCab Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...