Question about 2000 Daewoo Korando

2 Answers

Noise from offside rear wheel when turning, it sounds like a bearing but we don't think it is that, its not really a 'knocking' more of a scraping, grinding sound. Its not continious, seems to occur mainly when turning the car right.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 389 Answers

If its not the bearing's then must be the brake's worn. It sounds more like bearing trouble but its easily checked. Just jack it up put a bar under the wheel and with the handbrake off lift if up if the bearing is so far gone you can hear grinding or scraping then the wheel will move up and down without the axle. It still may be the brakes on the right hand side worn but the reason I think this is unlikely is you should get the grinding sound every time you brake. The reason for the grinding is because when turning right the diff put's more preasure on the side going slowest inside wheel when turning the corner. I had a problem like this before and it was bearings in the diff so all I can advise is start with checking the wheel bearing then brakes. These are checks you can do yourself so will have no cost. Hope this help's

Posted on Sep 06, 2009

Testimonial: "very prompt and helpful"

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

Have the front brakes checked alot of times the brake pads wear down to the point that the wear warning indicator starts to rub on the rotor or disc and makes a scraping sound when turning, your front brake pads are due to be replaced, I am 80% sure.

Posted on Sep 06, 2009

Testimonial: "so prompt thanks, very useful info"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wheel bearings noise from front wheels


Hi

It sounds like your CV joints are getting worn, the reason is that most of your driving is don in a straight line which wears a groove so when you turn from lock to lock the bearings clunk over the groove, it is annoying but not particularly dangerous in the early stages of wear

Jun 07, 2014 | 2006 Mazda 3

2 Answers

Clicking noise turning right


Could be a tire hitting the inner fender skirting. Check both front tires to see if they are clean/scraped right at the tread and side. This is a good indication that the tire is rubbing something. Also, since your turning right, you put more weight of the vehicle on the left side. You might want to check the front and rear wheel bearings on the left. I've heard them click before, but only under pressure.

Jul 13, 2013 | Chevrolet Cars & Trucks

1 Answer

When I am driving I hear a clicking noise. It sounds like it is coming from the rear of the vehicle


Hello, it wigit with his/here finger nail stripping the rubber of you tires in the back of you vehicle.
Is it a timely click that is unformed sound. Does the clicking intervals get louder with the speed increasing? It sound like a rear wheel bearing that out of grease. If it start squalling really loud. You will need to a new wheel bearing install. Don't let go to far it can out the wheel bearing and cause the particular wheel to come off. GB...stewbsion

Aug 26, 2011 | 2005 Jeep Grand Cherokee

1 Answer

Noise coming from rear passenger side wheel


Could be a bad wheel bearing or defective brake components. Jack the wheel up, spin it, and listen for the noise. If a 'scraping' sound, it is likely brakes. If more of a rumbling, grinding sound, then check the bearings. These are a greased-for-life bearings, so replacement is the only option. Hope this helps!

Sep 23, 2010 | 1991 Dodge Caravan

1 Answer

I have a 2003 Subaru Forester XT Luxury manual transmission with 100,000Km. The last 5000Km I have been increasingly aware of noise - hum rather than grinding or scraping or shadder - from rear end which...


Hello,
Noise can be also from some sticky brake pad, or the bearings of the rear wheels, or even some spoiler, but you should have noticed it right after installing, and it is another sound. As for the differential, there might be a broken tooth, or again bearings, regardless of oil state.

Nov 06, 2009 | 2003 Subaru Forester

2 Answers

Whistling coming from rear offside wheel


Sounds like brakes to me. Get them checked. Rear brakes go first on VW

Jul 04, 2009 | 2001 Volkswagen Beetle

3 Answers

Scraping noise from front wheel on 02 Saturn Vue


It could be the bearings inside the cv joint, but I would think the bearings inside the hub first.

Jun 29, 2009 | 2002 Saturn VUE

1 Answer

Ford F150 2004 4x4 passenger side rear wheel noises


You can try the bearings but I think if you take off the rear rotors and look at the emergency brakes you'll find the problem. You might want to ride the emergency brake a little in lieu of removing the rotors to confirm the problem. Also some wheel covers make noise-drive without them and see if it helps.

Jun 18, 2009 | 2004 Ford F150

1 Answer

93 Grand Caravan right rear wheel/brake problem(s)


well i can help with problem #2

even if you tightened the wheel bearing, it is probably worn out..

what it does when it's loose is you won't hear much noise when you drive on a strait road but the minute you put some weight on it, like when you take a curve, the weight of the body is applied on the bearing resulting in a scraping noise....

and the faster you'll drive the more noise you'll get

so let's say you take a left turn you're gonna hear noise from the right wheel...

Apr 29, 2009 | 1993 Dodge Grand Caravan

1 Answer

Right rear is making a sound of medal scraping medal. I believe it maybe the wheel bearings.


If it's a scraping sound, when does it happen? If it's when you hit the brakes, then it's likely your rear brake pads/shoes are down to the metal and are scraping. This can happen when you're not hitting the brakes, however. Bad wheel bearings are usually a moaning/roaring sound that increases as road speed increases. Ditto that for differential bearings - if they go out, you usually get a roaring noise that increases the faster you go.

Aug 10, 2008 | Ford Explorer Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

653 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...