Question about GMC Sierra 1500

2 Answers

Need to replace brake line from rear axle forward on a 1996 gmc sierra 1500 pu xcab. i need a diagram.

Posted by on

  • Anonymous Mar 16, 2014

    my 90 gmc sierra 1500 goes forward in drive fine but when try it in reverse it jus revs up n doesn't go?

  • Anonymous Mar 16, 2014

    my 90 gmc sierra 1500 goes forward in drive fine but when try it in reverse it jus revs up n doesn't go?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I need to find a brake line diagram for a 1999 gmc sierra 5.3

Posted on Jan 29, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,118 Answers

Chanses are it broke behind the gas tank wear it runs along the frame rail. You don't need a diagram to fix that, just unhook it at both ends and break it off or cut it off buy the tank and take the pieces with you to a auto parts store and they will match it up with new line, just take a tape measure and measure from the rear axel to the front block or perportioning valve, and don't worry about the piece behind the tank, just run the new line alongside the old one behind the tank unless you want to pull the tank out.

Posted on Sep 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

.brakes line locateions 1996 gmc 1500


Have to fabricate new brake tubing & just replace the rusted
lines as you see them.

If you get under there & look, you will have your answer

A guess from my experience, would say you start at the proportioning valve & go past the door & leak, to the rear
somewhere at a junction block on the axle housing or to an
abs hcu unit, if one of them there along the way

Sometimes you need to make two lines with a union under the door,
as that is the longest run under a truck & to do one piece may not be
possible & get it in place, with all the bends & things you have to pass

On a 1996, I would suggest you bleed all four corners first
Then remove the master cylinder & clean out the moisture
Then replace All rubber flex hoses
Then replace the entire brake system lines
Once one rusts out, their all months apart & unsafe to use
piece mealing it one section at a time

Apr 09, 2014 | 2002 GMC Sierra 1500

2 Answers

How to install a new rear axle in a 02 gmc sierra 1500


Jack it up ,pull the wheel on the bad axle side,remove the diff. cover,
remove the small pin holding the large pin in,slide the big pin out ,push the axle in from the wheel end,remove the c-clip in the axle and slide it out.
Would be wise to change the seal at the end af the axle tube at the same time. Slide the new axle in ,put the c-clip in the axle ,push it back in the carrier and reinstall the large pin and keeper pin,"Right Stuff" sealer makes a good cover gasket,3/8 drive for the fill plug,some gear iol and you're done,,not a bad job,no special tools required.

Feb 23, 2012 | 2002 GMC Sierra 1500

1 Answer

I need a diagram of the 2003 GMC sierra 1500 4wd brake lines


Check out www.autozone.com for this type of diagram. You have to register, but it's free.

Mar 05, 2011 | 2003 GMC Sierra 1500

3 Answers

Wiring diagram for 1996 gmc sierra brake asembly


The brake light switch is at fault. Get a new one and replace it. The location is at the brake pedal area mounted on a bracket with a plunger stud that rest on the brake pedal's arm the pad is attached to

May 08, 2010 | 1996 GMC Sierra

1 Answer

1997 gmc 1500 xcab reverse lights come on when braking


Sounds like someone put the bulbs back in the wrong holes in the taillight. Or two wires are shorting together. Either way , I think if you remove the taillights , you will find the problem easily.

Apr 15, 2010 | 1998 GMC Sierra

1 Answer

Where to find diagram to install whole rear brake lines on 1992 GMC Sierra 1500 series pickup truck


I don't know about a diagram. Just buy some 1/4 inch brake line and run it as close to the original as you can.

Apr 03, 2010 | 1992 GMC Sierra K1500

1 Answer

Rear passenger wheel and brake plate axle damaged


I would, Too be on the Safe Side. An Action like this Almost EVERY time will Warp the Axle and Cause Major Problems with the Suspension. I own a 95' Silverado and had a Similar Problem.

Jan 21, 2009 | 1996 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,071 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...