Question about 1999 Jeep Cherokee

Open Question

1999 cherokee replace injector on 3 cyl clear codes still bucking not stalling could this be a bad rotor and cap or crank sensor thanks

Posted by on

  • Richard Scordino May 11, 2010

    wires, cap and rotor can help if they are bad...seriously doubt it's the crank sensor...generally either they work and the engine runs or they don't and it doesn't. I'd check the plug in #3 as if the injector there failed, likely the plug is burned or fouled.

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

96 grand cherokee starts& runs fine but then it goes into pig mode & over fuels dumping black sout out of exhaust


1996 jeep grand cherokee stalling at lights or stop signs - Forums ...

www.cnet.com > Forums > Car Tech

CNETJun 11, 2015 - My jeep grand cherokee 1996 has started stalling when at lights, stop signs, in park or ... It starts and drives but after stoping at the stores and parking when I came out I ... Mechanic changed already crank sensor, distributer pick up, fuel pump, idle .... Symptoms like the Jeep running fine, then stalling without warning usually ... 97 Jeep Grand Cherokee Laredo keep dying upon ignition
Jun 11, 2015
1996 Jeep Grand Cherokee just stopped while driving.
Jun 10, 2015
More results from www.cnet.com
Missing: pig

Nov 23, 2015 | 1996 Jeep Grand Cherokee

1 Answer

Po302, 1999 Jeep Cherokee #2 cylinder misfire


Try checking fuel injector.
Try checking compression.
Is the engine running ok, maybe you're getting a bad code, if so you need to find out how to clear it, sorry I can't help you with that. Good luck

Sep 24, 2015 | 1999 Jeep Cherokee

1 Answer

My jeep grand cherokee 1999. starting up problem and shutting off while driving (not all the time). already replace crank sensor. any idea? thanks


if this is a 5.2 or a 5.9 its a bad cam sensor. its located just under the cap and rotor and its a round plastic ring with a wire harrness. you should have a code come up

Mar 13, 2013 | Jeep Cherokee Cars & Trucks

1 Answer

97 Grand Cherokee larado dies when you slow down or are stopped. Some bucking/stalling when driving it. We have replaced trottle sensor and igination coil; change air filter; but we did just install a new...


The ac compressor does put an additional load on the engine.
Any minor problem with performance can be amplified with the ac on.
I would check fuel pressure and look at the idle air control valve.
Also check the computer for trouble codes.
Both 6 and 8 cyl engines use a cap rotor and wires arrangement, so it wouldn't hurt to make sure those components as well as the spark plugs are in good working order.
The bucking on the road and stalling at stops could be two different issues.

Jul 21, 2012 | 1997 Jeep Grand Cherokee

1 Answer

Have a 1999 dodge dakota sport 4 wheel drive with a 5.2 liter motor 158,000 miles my problem is every 3 or 4 days when i go to start it it in the morning will not start after about 5 or 6 times cranking...


a vehicles crank shaft sensor sends a signal to computer, as to tell what revolution the crank is on. you may not get a check engine light. check injectors for leaking in to cylinders, it can cause an excess amount of fuel in cylinder. this may be causeing the no starts and flooding smell. if it starts good warm then check the injectors for leaking. good-luck!! you may also have a bad coolant tempurature sensor. symtoms of a bad cts are--poor cold idle, stalling, slow idle speed, cold hesitation or stumble, poor fuel milage. ( will also ****** timing). its hard to say with out being there, so check out above. good- luck!!

Oct 26, 2010 | 1999 Dodge Dakota

3 Answers

Rough idle


replace map sensor

Mar 17, 2010 | 1993 Jeep Grand Cherokee

3 Answers

I put my jeep in reverse and it stalls. When i put it in drive it


it sounds to me like your rpm is low which can be solved by takin intake off and sprayin carb choke cleaner into it. if that dont work your mass air flow sensor is probably bad. i had to replace 2 or 3 of them on my 99 cherokee

Apr 02, 2009 | 1992 Jeep Cherokee Limited

1 Answer

94 jeep grand cherokee missing after it gets warm


YOU NEED TO HAVE IT SCANNED TO ISOLATE WHICH CYL. PROBALY AN INJECTOR OR CONNECTOR OR CRANK SENSOR LEAD RUBBING INTAKE

Jan 25, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Jeep Cherokee Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...