Question about 1999 Nissan Sentra

1 Answer

IS THERE A PICTURE OF WHERE THE BLOWER RESISTOR IS ON A 99 NISSAN SENTRA 2.0 AND HOW TO GET TO IT

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

The resister is located under the right side of the dash by the blower motor.This will not be to hard to get to:)

Posted on Sep 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Sentra 2010 blower resistor location? Is there an easy way to get at it without removing the entire dash?


if it has blower resistors in a pack , they will be in the blower case to be cooled with blower air
it has a modular control talk with a service center as to where it is and how to get it out

Sep 26, 2016 | 2010 Nissan Sentra

1 Answer

Manual blower fan on 2005 altima stuck on high


Blower motor resistor is bad common issue with sentras, best to have a qualified Nissan tech replace it, due to the location of resistor

Mar 14, 2015 | 2005 Nissan Altima

1 Answer

How do I replace a blower resistor in a 2002 Nissan Sentra GXE?


Right next to the blower motor is the resister beneath the glove box,just remove connector,then 2 screws,can't tell by looking at it if it's bad,here's a link to what it look's like. Duralast Heater Blower Motor Resistor JA1625 2002 Nissan Datsun Sentra...

Sep 12, 2014 | 2002 Nissan Sentra

1 Answer

Trying to locate the blower motar resistor on a 2012 nissan sentra


the resistor is below the glove box. remove glove box, and you will see the blower motor. resistor is beside the blower motor. it only has a couple of screws.if you think you can get to it without removing glove box. this is fine.the resistor has about 4 wires going to it. good-day!

Apr 14, 2014 | Nissan Sentra Cars & Trucks

1 Answer

My 1995 Nissan Sentra heater fan only worked on high, so I replaced the blower motor resister and now it only works on the first 3 settings. Any idea why?


did you install the right resistor, or the resistor is defective, many problems with aftermarket resistors, try a dealer resistor.

Jan 20, 2010 | 1995 Nissan Sentra

1 Answer

The heater blower in my 2002 sentra is only woking when on the highest setting...do you know what the problem could be?


The blower resistors have gone bad and needs to be replaced.

The 2002 Nissan Sentra blower motor resistor is located near the blower motor itself, which can be found under the dashboard, on the passenger side of the car.

To access it, you have to remove the glove compartment and the isolation panel that covers the bottom of the blower. Do the following steps:

  1. first, locate and open the glove compartment on the passenger side;
  2. remove the four upper screws and slide the door lock bracket out;
  3. pull out the two pins at the inner bottom corners of the compartment;
  4. take out the glove compartment assembly;
  5. remove the two screws retaining the isolation panel and slide the later out.
Looking under the dashboard, you can now see the blower motor and, on its left side, near the firewall, the resistor block brown connector.

To take out the blower motor resistor:
  1. remove the white plastic bracket that faces it;
  2. unplug the brown connector;
  3. remove the two screws on the resistor's socket;
  4. pull the resistor block out.
The resistor block is actually a PCB ("Printed Circuit Board"). The traces printed on this board have different electrical resistance, and are used by the control assembly to vary the speed of the blower fan.

I believe Auto Zone or Parts Source has the blower resistor you need. Good luck

Nov 03, 2009 | 2002 Nissan Sentra

3 Answers

98 Nissan Sentra GXE Blower only works on highest setting?


There is Blower Motor Resistor located at the passenger side, right side at the feet. Mounted by 2 screws. You should be able to see electrical connector going to it. Replaces in minutes.

Jul 02, 2009 | 1998 Nissan Sentra

1 Answer

Nissan sentra 1998 air conditioner problem


The problem is most likely one of the following:-

1) Open circuit blower motor series dropping resistor - this resistor module is usually located in the blower motor ducting in the air flow.

2) Faulty fan speed control switch, or poor connection in the associated wiring.

Don't know cost of these items.

Jun 18, 2009 | 1983 Nissan Sentra

2 Answers

99 Nissan Altima blower fan works only on highest setting (#4)


Resistor switch. The rotary switch on the dash is very, very uncommon. It is also not the blower, because it works.

Mar 09, 2009 | 1999 Nissan Altima

Not finding what you are looking for?
1999 Nissan Sentra Logo

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...