Question about 2000 Oldsmobile Intrigue

Open Question

All warning lights are on

I have the same problem.Did you get yours fixed?And if you did what did it end up being?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Warning lights panel doesn't come on. No warning lights.


Check your ground connection to the warning light cluster. Either the ground wire has come loose or the connection to the chassis has corroded.

May 07, 2015 | 2000 Dodge Caravan

2 Answers

In my 2006 ford fusion 2.3L whenever I put my key in the ignition and turn it a weird solid ringing sound start and stops 5 seconds later hat could it be?


Not surprisingly, many others have experienced problems with the ignition switch on this car. Historically, it is not a sound, but that the key is stuck in the ignition. http://repairpal.com/key-will-not-come-out-of-ignition-570 Your problem sounds different, but it may be related. Although I do not recommend the fix in the link above, it is possible the previous owner of your car did perform this fix and it has resulted in the problem you now have. My better guess is that the chime/buzzer has failed due to moisture or dirt and is no longer producing the sound that it should, but instead is altered to the ringing you describe.To disable follow these instructions:

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, at a moderate speed, buckle
then unbuckle the safety belt 9 times, ending in the unbuckled state.
(Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.)
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
This will disable the BeltMinder feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.
This will enable the BeltMinder feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.
I hope this helps. Good luck.

Jun 12, 2014 | 2006 Ford Fusion

1 Answer

My 1998 lincoln continental is smoking burning and through oil.but none of my warning lights are indicating something is wrong what could this be?


Heavy use of engine oil and a nasty smelling smoke usually means the piston rings and cylinder bores are worn out or if you only get smoke on a closed throttle it can point to failed valve stem seals, (cheaper to fix but may point to other wear problems about to show up). The oil pressure warning light is not coming on because the crank shaft and bottom end of the engine are still (possibly) ok.

Jan 26, 2014 | 1998 Lincoln Continental

1 Answer

Citroen c-crosser anti pollution warning light


We had this with our grand picasso all the warning lights on then car went into limp mode replaced two lambda sensor as this is what citroen thought it was in the end coolant sensor was leaking up wire back to ecu making all kinds of lights come on as it malfunctioned in the end new ecu cost over thousand pounds.

Jul 01, 2012 | 2008 Citroen C-Crosser HDi

1 Answer

Left the keys in the ignition adn had AAA jump it. Now the T/C with a slash through it came on and the light that says low engine power. The car starts really rough and has no power when u drive it. WHats...


T/C light = Traction Control

Could be something going on with a wheel speed sensor. You'll have to have the ABS/TCS controller scanned for any stored trouble codes to see why the controller is turning on the light. The code(s) might help you to determine what part of the system is faulting. You'll have to take it to a shop that has a high end scan tool.

If the TC light is on, chances are there is a trouble code set and stored in the computer. You need to determine what the code is. If you take the car to a nationally recognized parts store, most will scan the computer for free, so there is no money out of pocket for you.


Actron also makes a ABS code checker called BrakeScan. Don't know how good it is, but it might be good for a DIY person.

TC Explanation:

If your vehicle is equipped with the Enhanced Traction System (ETS), this warning light should come on briefly as you start the engine. If the warning light does not come on, then have it fixed so it will be ready to warn you if there is a problem.
If the warning light stays on, or comes on when you are driving, there may be a problem with your Enhanced Traction System and your vehicle may need service. When this warning light is on, the system will not limit wheel spin. Adjust your driving accordingly.
The Enhanced Traction System warning light may come on for the following reasons:
If you turn the system off by moving the shift lever to FIRST (1), the warning light will come on and stay on. To turn the system back on, move the shift lever back to a position other than FIRST (1). The warning light should go off. The warning light will come on when you set your parking brake with the engine running, and it will stay on if your parking brake does not release fully. If the transaxle shift lever is in any position other than FIRST (1) and the warning light stays on after your parking brake is fully released, it means there is a problem with the system. If the traction control system is affected by an engine-related problem, the system will turn off and the warning light will come on. If the Enhanced Traction System warning light comes on and stays on for an extended period of time when the transaxle shift lever is in any position other than FIRST (1), your vehicle needs service.


Thanks for using FixYa - a 4 THUMBS rating and POSITIVE TESTIMONIAL are appreciated for answering your FREE question.

Oct 09, 2010 | 2006 Chevrolet Cobalt

1 Answer

How to disable seatbelt alarm on 2003 F-150?


There is a procedure in the owners manual on page 110.

BeltMinder activation and deactivation procedure
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT START THE ENGINE.)
2. Wait until the safety belt warning light turns off. (Approximately 1–2 minutes.)
• Steps 3–5 must be completed within 60 seconds or the procedure will have to be repeated.
3. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This can be done before or during BeltMinder warning activation.
4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.
5. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled
• After step 5 the safety belt warning light will be turned on for three seconds.
6. Within seven seconds of the safety belt warning light turning off, buckle then unbuckle the safety belt.
• This will disable BeltMinder if it is currently enabled, or enable BeltMinder if it is currently disabled.
7. Confirmation of disabling BeltMinder is provided by the safety belt warning light flashing four times per second for three seconds.
8. Confirmation of enabling BeltMinder is provided by:
• The safety belt warning light flashing four times per second for three seconds.
• Followed by three seconds with the safety belt warning light off.
• Once again, the safety belt warning light will flash four times per second for three seconds.
9. After receiving confirmation, the deactivation/activation procedure is complete.

If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Dec 20, 2009 | 2003 Ford F150 Regular Cab

1 Answer

Don't know what warning light means


What exactly does the warning light look like? It is probably the transmission warning light. The transmission uses the radiator to cool the transmission fluid. You need to have your cooling system serviced on a 10 year old car. Drain, flush, fresh coolant, new thermostat. A full service. Keep driving and you may end up with a transmission repair. Good luck.

Nov 17, 2009 | 1999 Saturn SL

1 Answer

Warning lights remaining on


u need to go to specialist and get reset the car computer and that is the end...reason batery removing......

Jun 08, 2009 | 1999 Hyundai Sonata

Not finding what you are looking for?
2000 Oldsmobile Intrigue Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...