Question about Ford Bronco

1 Answer

I have a 79 bronco the power steering hose blew off so i replaced the hose that didnt fix it i put on a power steering pump still didnt fix it so i bought a gear box and put that on still didnt fix it. it will turn one way normal but the other way it wont turn with power steering. what do i need to do to fix it? if it matters i have 35 in tires on it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 132 Answers

You need to jack up the front wheels with the key half on so the steering is free and the motor off turn the wheels left to right all the way slowly this will bleed the system repeat as needed one time will not be enough ,you can check with starting the engine and cranking the steering to see if it is free of air .

Posted on Sep 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Power steering fluid leaking, empty every 2 days


Fix the leak ! replace the hose etc... Take to a qualified repair shop etc......

Aug 25, 2016 | Cars & Trucks

1 Answer

How do I replace power steering pump on a 1993 Buick centry


place a drain pan under pump. disconnect negative battery cable. remove inlet and outlet hoses a.d let drain. remove the serpentine belt from the pulleys by loosening the automatic belt tensioner. remove the three pump mounting bolts and the pump. using a suitable pry bar remove the retaining clips from the reservoir separate the reservoir from the pump. install the reservoir to the pump with new o ring seal. remove pump pulley and put on new one.

Oct 27, 2013 | 1989 Ford Bronco II

1 Answer

Power steering pump blew a hose off and now whines.


Have you checked the level of fluid in the pump? If it is full, you may have damaged the pump with it ran low. Try a Power Steering Lubricant first but if it is full and still making noise it is time to replace.

There are a few models that use the power steering pump at the booster for the brakes, but I doubt that yours is that. Look at the brake master cylinder. If it has this big round black drum, you have a vacuum assist and there is no correlation. If it has a couple of hoses going to an item behind the master that look like the hoses on your power steering there may be a correlation. Most of the diesels had the power steering booster.

Hope this helps

Jan 28, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

79 vette i changed the power assisted steering hoses


Sounds like you blew out the rack.Double check that you installed the correct hoses and fluid on/in the vehicle. Bleed the unit by turning the steering wheel from stop to stop while the vehicle is running until there is no foaming or bubbles in the resovoir. If this
doesn't cure it then take it to a shop and have them pressure test the pump and rack . The tester can be pricey and the procedure is a little dangerous. If you have the tester by all means use the service manual and it will tell you the correct procedure for hooking up the tester and how to use it. But be careful and wear safety lenses and gloves.Power steering fluid is very hot and the pressures are high. If you determine that it is the rack replacing this is an adventure and your gonna need a wheel alignment after its done. I suggest you take it to a shop where the Tech's are ASE Certified. Good luck and keep me posted

Oct 23, 2009 | 1980 Chevrolet Corvette

1 Answer

Power steering hose blew


Generally it should work it's way out by itself, but you can remove air by turning the wheels all the way in one direction (hold it there a few seconds) then repeat in other direction...check fluid level and that's all. If noise lasts more than a few hours, then pump has sustained some damage.

Apr 22, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

3 Answers

Power steering leak on a 1988 full size bronco


The gear box is a common problem on this model. That would be the place I would start. A cheap, temporary fix is to go to your local parts store and ask for Lucas Power Steering Stop-Leak. It will buy you some time.

Apr 09, 2009 | 1988 Ford Bronco

2 Answers

Power Steering Recently my power steering pipe blew and started leaking due to it comming in contact with the engine. Is it possible to remove and replace this pipe or is it a sealed unit to the steering...


if it's the low pressure side i'm sure a mechanic can replace just the broken part. if it's the high pressure side, best off just to get a new hose. if not, the hose is likely to leak again on the high pressure hose if the unit isn't replaced.

Mar 12, 2009 | Ford F Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...