Question about 2007 Jeep Commander Rocky Mountain

Open Question

ESP/BAS ABS TCS and SERVICE 4WD SYSTEM warnings all came on

The ESP/BAS ABS TCS and SERVICE 4WD SYSTEM warnings all came on at once in my 2007 JEep COmmander. Any Ideas?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bas/esp light is on inmy jeep commander 2006


This video is for a liberty, but all Jeeps should be similiar.
Jeep Liberty How to fix Traction ABS EST Light Codes C1240 C123F Also a guy in a forum says that it might involve a recall of the DCX recall applying to ABS modules on many Chrysler, Dodge, & Jeep products including the Commander. I'd call your dealer and ask, they might fix it for free if it's a recall. http://www.jeepcommander.com/forums/5-general-commander-discussion/1483-esp-bas-traction-control-light-staying.html

Nov 17, 2016 | Jeep Cars & Trucks

2 Answers

Fault code c 1044


Think I found the solution or a thread discussing your Fault Code at Jeep Forum (Jeep patriot abs,4wd,esp,Trac control lights on after replacing rear wheel bearing) Jeep patriot abs 4wd esp Trac control lights on after replacing rear wheel...

Jan 07, 2016 | 2007 Jeep Patriot Limited

1 Answer

Abs light stays on and the esc indicator light also but when you start it it shows it off


the operators guide shows what these mean and what to do.
lost that>? i have one, and 08 JK.
pages 105 to 116
it resets each drive. the opr guide says that, and does.
its a very complex system, you should RTM.

ill quote your missing pages.
ABS:
If the light remains on after start-up or comes on and
stays on at road speeds, it may indicate that the ABS has
detected a malfunction or has become inoperative. The
system reverts to standard non-anti-lock brakes.
ESP:/TCS
The ESP/TCS Indicator Light (located in the instrument
cluster), starts to flash as soon as the tires lose traction
and the ESP system becomes active. The ESP/TCS Indicator
Light also flashes when TCS is active. If the
ESP/TCS Indicator Light begins to flash during acceleration,
ease up on the accelerator and apply as little throttle
as possible. Be sure to adapt your speed and driving to
the prevailing road conditions


is this clear? if not ask more, questions , more specific and we can peel the onion deep as you want.
also wiki this topic, to understand it ...

Mar 08, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

I had my slave cylinder and clutch plate replaced. they also replaced the driver side cv axle and now the ABS and ESP/BAS and TCS lights are on. oh and my reverse lights don't turn on. Is there an


ABS problem may be related to the axle work...either a sensor was left unplugged, got damaged or is obstructed by rust. Reverse lights are on a separate system and likely, they weren't working and you just noticed. I'd have the shop that did the work check it over. If for any reason you don't want them doing that, have another shop do that and document what they found.

Mar 12, 2013 | 2007 Jeep Compass 2.4

1 Answer

2007 JEEP LIBERTY ESP BAS ABS WARNING LIGHTS


i took my 2007 jeep liberty 4x4 to the carwash but it was freezing out side as soon as i came out of the carwash the esp abs the skid car in the middle came on

Apr 09, 2012 | 2007 Jeep Liberty Sport

2 Answers

My esp and bas light will not go off on my 2007 jeep wrangler how can i get it off and what does it mean and also is thera a code that i need to get it off


The ESP/BAS system is a separate system from the engine computer/check engine light system, if your steering wheel is off center just a 1/2 degree, the light will set. Most scanners will not detect a code. It takes the Jeep protocol to reset it.
I hope this helps.

Sep 13, 2011 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

My 2008 jeep liberty has an issue. While driving back from TCU game (and TCU won !! my daughters in the band), it made a warning noise and lights on dash came on. ABS, ESP, ESP BAS, serv 4wd and cruise...


I had this same problem with my Jeep Liberty 2008 and it need a new computer
module...it was very expense thank the Lord that I was still under warranty.

Sep 19, 2010 | 2008 Jeep Liberty

1 Answer

I have a 2007 Jeep Compass Limited 4x4 and the ABS, 4WD, ESP BAS and Anti-Slip lights are all on at the same time. They came on while driving and have went off then back on a few times and now they just...


The lights are being turned on by your BCM or Body Control Module. It's located under the driver's side knee bolster, but it will probably have to be taken to the Dealership to hook up their DRB III to ascertain as to why the BCM is turning on all of your lights.

"00 Buck"

Nov 06, 2009 | 2009 Jeep Compass

1 Answer

BAS / ESC warning light


there is a software update for this vehicle to cure this problem...contact your dealer

Aug 08, 2008 | 2007 Jeep Commander Rocky Mountain

Not finding what you are looking for?
2007 Jeep Commander Rocky Mountain Logo

Related Topics:

2,376 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...