Question about 2001 Toyota Camry

2 Answers

My engine light went on last week. i brought it to my usual mechanic he checked it and found nothing wrong mechanically so he reset it. today the light went on again what do i do

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 132 Answers

This could be the 02 sensors getting a false reading from the fuel your useing , try filling up with a little higher octane gas.

Posted on Sep 05, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,004 Answers

There is a procedure to turning it off since you are sure nothing is wrong after the scan.

remove the bettery connectors for 5 minutes and connect back.

This should fix the light.

Cheers.

Posted on Sep 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Engine light on after oil change but mechanic can't find problem


could be the oil change timer that needs to be reset look at you manual and see how to reset it , here is a you tube vid on how to do it http://www.youtube.com/watch?v=QDKCAIeOHeA

Nov 25, 2013 | 2008 Cadillac Cts

1 Answer

Engine warning light stays on


Check your gas cap. Whenyou put in gas the motor is suppose to be off. If there's not a good seal on gas cap that will cause the check engine light to come on. The mechanic should have a code reader for you and tell you what the light means.

May 29, 2013 | 2005 Ford Focus

2 Answers

I changed my spare plug wires but still the engine service soon light still is on


I have a 1999 Mercury tracer. I was driving down the highway two weeks ago and my check engine light came on. i went to autozone and he said something about misfire on bank and vacuum leak. He said it bascially was a tune up. i got in my car the next day and the light went off. it didnt come back on. Last sunday i got a tune up and a oil change. i was driving to work today when my service engine soon light came back on. could it be because its been warm here in st louis and all of a sudden its cold. or do i just need to get it reset. i hope its nothing major because im broke right now and cant afford to get it fixed

May 02, 2012 | 1999 Mercury Tracer

1 Answer

2004 Jeep Grand Cherokee temp gauge high when heat is on


If your "check engine" light is turn on, I suggest scanned the PCM to know exactly what fault code is stored there. Additionally, could be some problem with the "temp sending unit".

Keep us updated.

Jan 23, 2012 | 2004 Jeep Grand Cherokee

1 Answer

There is a small thud when the car starts to run, on the first gear. after a few occurrences, the check engine light turns on. When I brought the car to the service center, the mechanic did reset the...


Find a new mechanic!!! Is your factory warranty over?
Can you tell where the thud is coming from? Engine area, under vehicle, in the rear? When the check engine light is on, go to a place like AutoZone and have the code scanned, and have them give a printout. post that info here.

Aug 28, 2011 | 2008 Chevrolet Trailblazer

1 Answer

Hi, our 2003 focus wont start. The engine light, the ignition light and the oil light are all on. We have checked the battery and all the fuses but nothing there seems wrong. We've only had this car for...


could be the belt tensioner is bad. That will loosen the belt so the car battery goes weak and will make a bad noise. Could have gotten a defective alternator.

Mar 07, 2010 | 2006 Ford Focus

2 Answers

Blinking Check engine light began today after my mechanic said that one of the fuel injector is not working properly, I ma going to get it fixed tomorrow morning, I need to drive about 35-40 miles to home...


If the vehicle is experiencing an engine mis-fire, causing an overly rich condition and poor drivabilty, this can lead to other problems with the Catalytic converter becoming damaged. I'm not sure how the engine runs at this point, but I thought this was worth mentioning.

Feb 03, 2010 | 1996 Nissan Altima

1 Answer

Toyota Corolla 2008 with 9000 miles occassional gas fumes inside car starting about a month after I bought the car..can happen a few times in a week then not for a few months. Usually starts after I am...


they need to check under your back seat and see if the seal is still working your gas tank sending unit is under your back seat .toyota needs to do this for you

Jan 14, 2010 | Toyota Corolla Cars & Trucks

2 Answers

How do i reset the check engine light?


disconnect the battery......wait three to five minutes. reconnect

Dec 29, 2009 | 2005 Mercury Montego

Not finding what you are looking for?
2001 Toyota Camry Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...