Question about 1995 Chevrolet K1500

Open Question

It turns over but no Catch New Didtributor Cap

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rough idle and poor acceleration


P0300 Random/Multiple Cylinder Misfire Detected
---------
zed-bull key programmer

Jan 28, 2013 | Cars & Trucks

1 Answer

Replace the distirbutor


Disconnect the battery. take cap off but leave wires intact. Check position of rotor for reinstalling. Loosten bolt under distributor and take out. Lift didtributor and turn rotor counterclockwise to remove dist. Make sure you put back in same identical spot.or vehicle will not run. Mark spot on motor where rotor is if you can't remember. You have to turn rotor counterclockwise to have dist. fall back into same spot. Will be tough to get out at first. Don't spray with penetrating oil. Just pull up and turn.

Jan 19, 2013 | Chevrolet Blazer Cars & Trucks

2 Answers

How to do a oil change


Pull the drain plug, change the oil filter, replace the drain plug. Add oil until the dipstick reads full. Start the engine and make sure the oil light goes out. Check for leaks around the oil filter with the car running. Recheck the oil level, add as necessary. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Jan 15, 2012 | Toyota Starlet Cars & Trucks

2 Answers

Im tring to remove my oil fill cap, when i turn it couterclock wise it just clicks is there a way i can remove it


Try pushing down on the cap. Sometimes when downward pressure is applied to these oil fill caps, they will catch and then they can be removed. Once you do remove the cap, be sure to replace it.

Good Luck!

Feb 26, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

Still miss firing after i changed coil pack, engine will miss fire on all 4 plugs after temp comes up past half way. its ok for the first bit you take it. new plugs and wires.


buy new spark plugs and didtributor cap maybe rusty and wet. put injection cleaner to your tank 8 oz. only and let run few minutes. hope this will help.

Jan 11, 2011 | 1998 Chevrolet Cavalier

1 Answer

I can't put back on the distributor cap on tight. I am replacing the spark plug wires and the distributor cap wont stay on tight enough. It is loose.


Inspection of the cap may find that the places that catch the holders are chipped off the cay and that a new cap is needed. If the cay is new it is likly the wrong one as two brands of distrubuters were used and you may have been sold the other one

Apr 21, 2010 | 1996 Honda Accord

1 Answer

Wont start in wet weather


the coil pack is a series of coils if he replaced the pack then all the coils were replaced. now the question is were they new or were they a junk yard part. try replacing the rotor under the distributer cap.

Mar 30, 2010 | 1997 Isuzu Hombre

2 Answers

My `93 subaru legacy 2.2 turns over but won`t start


Could be as simple as a new rotor and distributer cap. As the rotor and contacts inside the cap wear, it will take more and more revolutions to get it to catch.

Sep 04, 2009 | 1995 Subaru Legacy

1 Answer

Car wont start


Check the ignition system for spark at the plugs. I had a similar problem a few years back with mine. Engine died while I was driving along on the interstate. Turned out that the spring pin holding the bevel gear to the bottom of the didtributor shaft had broken in three pieces. Installed a new pin, installed the distributor with the #1 cylinder at TDC, and it fired right up.

Jun 01, 2008 | 1993 Mercury Villager

Not finding what you are looking for?
1995 Chevrolet K1500 Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...