Question about 1997 Buick Skylark

Open Question

Engine hesitates with pedal to floor atfirst then after a few minutes all ok even at 80mph

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a weber 32/36 on my 86 Nissan 720 the truck runs fine but has a lack of power, and when I would push the accelerator all the way while driving the truck hesitates like there's not enough fuel,when I...


sounds like engine need some cuddle :) I mean, first thing to do is to check engine compression ratio. If that is ok, then make sure carb adjustments are correct and all fuel lines ar clean. Good luck!

Feb 13, 2014 | Cars & Trucks

3 Answers

06 titan truck won't accelerate even when the gas


If the engine RPM's increase when the gas pedal is floored, you have a transmission problem or a problem with your shift cables.

If the engine RPM's don't change when the gas pedal is floored, you have a throttle pedal cable problem or throttle body problem.

You will need an experienced mechanic to diagnose this problem as it is very dangerous to operate the vehicle under these conditions.

Oct 07, 2011 | 2006 Nissan Titan

1 Answer

I recently purchased a 2003 hyuandai tiburon GT with 171k miles on it i was on the interstate doing 80 mph in 4th gear at around 6k rpm when my clutch pedal dropped back into the floor board and just...


hmmm... 80mph @6000 rpm is not normal. you are needing a lot of power to produce 80mph. it seems clutch assembly needs replacement. clutch assembly includes clutch disc, fly wheel, and release bearing. might as well check your clutch master if the vacuums are still working properly. this might be the culprit to the stuck up clutch pedal.

after replacing the clutch assembly, you can reach 80mph @ 4000-4500rpm

Aug 06, 2011 | 2003 Hyundai Tiburon

1 Answer

Engine will turn over, but will not start


Suggestion, don;t try and start the car with the gas pedal pushed to the floor. Asking for trouble in the future.

Could be a fuel pump, clogged fuel filter.

Check engine light on? If so, Have the code read/scanned at your mechanic, or your local auto parts superstore.

Apr 01, 2010 | 2004 Ford Explorer

1 Answer

Pedal to the floor, topped up fluid - brakes OK, warning light ON


If you have an ABS computer, unplug it for a few minutes, the light should clear.

Sep 13, 2009 | 1990 Nissan Pulsar

1 Answer

96 Crown Victoria runs rough when first started, idles smooth after a few minutes but has no acceleration before running for 20-30 minutes. Replaced the egr valve..little help, loses acceleration on the...


Ahhhh!, if only we could turn back the hands of time. Is the vehicle sending any signals like blue smoke through the exhaust, or using a lot of oil. Possibly running on after the ignition is turned off.These are all indications of high milage wear internally. Rings, bearings, etc.etc. Low oil pressure? Blinking oil light when at intersections. Any of the above?

Aug 24, 2009 | 1996 Ford Crown Victoria

1 Answer

Replaced head gaskets


What size engine does it have? Sounds like a timing problem.

Jun 19, 2009 | 1999 GMC Sonoma

Not finding what you are looking for?
1997 Buick Skylark Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...