Question about 1991 Plymouth Sundance

Open Question

Car cuts back when you are applying gas

1991 Plymouth Sundance 2.2L
Car cuts back when you are applying gas. Just got the catalyst converter done and the car ran good but now it is cutting back again?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas leak at the middle pass.side of car.


find the fuel leak, then cut the line out in that section that leaks. go to any auto parts store and buy fuel injection hose for your car. and 2 injector line clamps, put the length of hose where you cut bad line out. clamp it good, test for leaks, then your ready to go ! good-day !

Mar 31, 2012 | 1992 Plymouth Sundance

1 Answer

I have a 1989 sundance, it wont start when its cold out. once it gets alittle warm it starts.. whats wrong with it? please help


I think this TSB will solve your problem even know your car is older.



NO: 18-05-96 Rev. A
GROUP: Vehicle Performance
DATE: May 24, 1996

SUBJECT: **Intermittent Rough Idle**
NOTE: This bulletin supersedes technical service bulletin 18-05-96 dated February 16, 1996 which should be removed from your files. The subject description was printed incorrectly and is marked with **ASTERISKS**
MODELS: 1991 - 1995 Acclaim/Spirit/LeBaron Sedan 1991 - 1993 Dynasty/New Yorker/New Yorker Salon 1991 - 1993 Daytona 1991 - 1995 LeBaron Coupe/LeBaron Convertible 1991 - 1994 Sundance/Shadow/Shadow Convertible 1991 - 1995 Caravan/Voyager/Town & Country NOTE: This bulletin applies to vehicles equipped with 2.2 liter and 2.5 liter engine and high pressure throttle body fuel injection.
SYMPTOM/CONDITION:
An intermittent rough idle may occur during cold engine operation, within 3 minutes after engine start up, in rainy weather and temperatures of approximately 30° to 50°F.

PARTS REQUIRED:
Quantity Part Number Part Name 1 4288298 Idle Air Control Motor (IAC) REPAIR PROCEDURE:
  1. Remove A/C motor.
  2. Install new IAC motor (P/N 4288298) and rubber O-ring, torque to 2 Nm (17 in. lbs).
CAUTION: The rubber o-ring must be installed with the IAC motor for proper operation.

I would also recommend doing a fuel pressure test to see if it loses fuel pressure overnight.

Feb 10, 2011 | 1989 Plymouth Sundance

2 Answers

When trying to start my 1991 Plymouth Sundance America I hear only a clicking sound. I replaced the battery but it did not work. Can it be the alternator?


sounds like you have a bad starter.not your alternator.if the battery is good the car should start even if the alternator is bad.you can even drive the car until the battery runs low.the alternator job is to keep the battery charged.soulds like the solinoid is clicking.but no responce from the starter.have starter checked.

Dec 08, 2010 | 1991 Plymouth Sundance

1 Answer

How to fix emergency brake on 1991 plymouth sundance. when i push down all the way the brake light in the dash comes on but the car doesnt stop


There is a wire split under the car on driver side,but follow the wire and you should run into the prob.

Oct 27, 2009 | 1991 Plymouth Sundance

2 Answers

Where is the fuel filter


To the rear of the gas tank under the car.

Oct 20, 2009 | 1994 Plymouth Sundance

1 Answer

Tire pressure recommendations have worn off the door jamb and I can't find online manual to get the recommended tire pressures for 1991 Plymouth Sundance


tire pressure is not a relly big deal usually a cars pressure is at 32psi even 35 would be good depends if u got a car fool ant traveling then 40psi but around town 32 is perfect for ur vehicle if u whish to proceed in ur search for manufacture recomandation thats ok but 32 to 35 is normal

Sep 01, 2009 | 1991 Plymouth Sundance

1 Answer

I have a 93 Plymouth Sundance that has been running good until just a few days ago. When I now start it up, when stepping on the gas to head down the road, I can hold the pedal to the floor and it will...


Start with cycling your key, on ,off, on, off, on, leave on (not start)and count if check engine light flashes. For example: flash,flash,pause, then 2 more flashes is code 22. 3 flashes, pause then 3 more, is code 33 etc... Code 55 is end of message. Get back to us if you get any.

May 07, 2009 | 1993 Plymouth Sundance

1 Answer

Intermittant loss of acceleration on my 1991 plymouth sundance


Turn key, on, off, on, off, on & leave it on (not start) & count check engine flashes. 2 digit codes, for example: flash, flash, flash, pause, flash,flash., is code 32

Mar 29, 2009 | 1991 Plymouth Sundance

Not finding what you are looking for?
1991 Plymouth Sundance Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...