Question about 2003 Chevrolet Venture Passanger

Open Question

2003 chevy venture van power from ignition etc. to box behind drivers seat but not sure what wires could be not working because van turns over but wont start what ae the possible problems

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 venter van Chev.radio come on no sound yes on star turn off for long time .


Check the fuse box for the radio, or check the wiring to the radio. Check this site for fuse box and fuse location in the box ...


Fuse Box Diagrams and Relays 2001 Chevy Venture

Feb 10, 2015 | 2001 Chevrolet Venture

1 Answer

2003 chevy venture problems


Yes the battery can be effected (drain) but in any kind of weather, unless you turn the radio off when you turn the engine off. The power wire in either application is connected directly to the battery as opposed to being connected to the ACC terminal which will be switched on and off with the ignition. You should connect the power wire (should be RED in color) from the radio plug to the terminal (marked "acc") on your fuse box located somewhere under your dash board. It sounds as though it's possible that the RED power wire and the YELLOW "Memory" wire have been switched, the power wire should be switched with the ignition and the Memory wire should be connected directly to a Battery terminal (marked as Batt also on the fuse box) or to the battery itself. All of these wires should be labeled with a small tab indicating there connection. Example Red wire marked (+ poss power), Black wire (- Neg Ground) Yellow wire (Memory) and usually 2 Green, 2Grey, 2 Blue, 2Purple as for the Speakers Poss. & Neg. respectively.

Dec 29, 2013 | Cars & Trucks

1 Answer

My Chevy venture 2002 van doesn't start. Good


You replace parts as part of your preventative
maintenance program,not to solve a problem
When working on a problem only component testing
will find the issues
You need to check for fuel pressure at the motor with a gauge
You check spark with a test plug you buy,not ground a plug
or wire on the vehicle
You can check for compression or cylinder leak down
to test some mechanical issues
I would assume ALL Fuse & links have been checked,as
well as battery voltage 12.6 v or more & cables etc
The ignition switch could be bad,turns starter but not all
the internal contacts are good

Jul 26, 2013 | Cars & Trucks

1 Answer

Need fuse box diagram for chevy g20 van


look at fuse box behind drivers seat, as well as under dash in front of drivers seat,,all top lights,and mood lights behind drivers seat, small door on side of van apx 2 feet back of drivers seat

Nov 20, 2012 | 1995 Chevrolet G20

1 Answer

Where is the powertrain control module located in a chevy venture 2003 van?


The pcm is located inside the airbox in the drivers side front corner of the engine compartment. You need to remove the air filter, and it is an aluminum box with fins at the bottom of the box.

Aug 18, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

My Chevy Venture 2003 door chime on drivers side chimes without key in ignition with door open. Before this happened my dash lights acted funny and then went out. When I shut off the van and opened the...


Sometimes the ignition key does not "deactivate" when removing the key...try wiggling the washer behind where the key goes...sometimes this sticks...:)

Dec 08, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

I need a wiring diagram of the power seat for a 97 chevy venture van


CHECK POWER SEAT FUSE.IF FUSE OKAY.CHECK FOR POWER AT SEAT SWITCH IF YES.HOT WIRE POWER SEAT MOTOR STILL DONT WORK. POWER SEAT MOTOR FAULTY.NO POWER TO SWITCH AND FUSE GOOD CHECK FOR A OPEN OR BROKE WIRE FROM THE FUSE BOX TO THE POWER SEAT SWITCH.

Oct 17, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

Have a 1992 chevy g20 van. the van has a tv/vcr


you'd have to find out what colored wire is behind the plugged in vcr wire theres gonna be a black n red , or black n yellow ( something like that) the black is ground ( frame/body Connected) the colored wire will usually be the powered side. , then follow that colored wire to the fuse box and relocate that powered side wire to connect to another wire , down at the fuse box that powers up with the key on. just connect it to the appropriate wire. stereo shops or car dealerships can fix that issue real quick. normally for a few dollars.

Jul 31, 2010 | 1992 Chevrolet G20

2 Answers

Electronic Control Module Installation 1994 G20 Chevy Van


I just had the same problem. If it is a regular van try under the driver seat in a plastic box. If it is a conversion van try in a pannel just behind driver seat on side of van wall behind a pannel that looks like a vent.

Dec 28, 2008 | 1987 Chevrolet G20

2 Answers

Thermostat in a 2003 chevy venture van


no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Nov 27, 2008 | 2004 Chevrolet Venture Passanger

Not finding what you are looking for?
2003 Chevrolet Venture Passanger Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...