Question about 1995 Jeep Grand Cherokee

4 Answers

I would like to disable the factory anti-theft and

I would like to disable the factory anti-theft and security system on my 1994 jeep Wrangler with 4 cylinder.

It drains the battery when left in storage/not driven for 2 months while on vacation. Then when trying to charge the battery the alarm goes off and the jeep will not start..

Posted by on

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Try Turn your vehicle on, while its on unhook the alarm box from behind the dash. if you attempt to do this without the vehicle on it will not work. an other solution would be to ground the purple and yellow wire on the drivers side door

Posted on Sep 05, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

You should take key and lock and unlock all doors it will reset system

Posted on Sep 05, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

To disable the factory anti-theft in this vehicle the programming in the ECM needs to be changed, the only computers capable of this are at dealerships.

Posted on Sep 05, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi, I have a 97 grand cherokee limited and the alarm system is on but i don't have the remote to stop it.When i put the key on the driver door and turn right and left,the alarm stop but when i try to start the truck the alarm start again.How can i stop the alarm or disconnect it forever?
Thanks

Posted on Mar 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 cutless supreme it will start and only run about 10 seconds then die


Does it have anti-theft system ?
The vehicle theft deterrent system is designed in order to prevent vehicle theft by disabling the fuel injectors unless the lock cylinder is correctly engaged by a mechanical key. The theft deterrent system uses the following 4 components for theft prevention:
• The lock cylinder
• The ignition switch
• The body control module (BCM)
• The powertrain control module (PCM) Do you have a SECURITY light lit on the dash ?

Mar 10, 2016 | Cars & Trucks

1 Answer

I just replaced the battery in my 2010 dodge avenger and now the blue light (Which I assume is the factory security or anti-theft) is blinking rapidly and I am afraid thats what drained my old battery to...


Some anti-theft systems need to be reset after the battery has died and/or been replaced. Check your driver's handbook for more information on this.

Feb 13, 2014 | Dodge Avenger Cars & Trucks

1 Answer

Security light blinking on 08 wrangler after changing battery


This is a normal condition and refer at anti-theft system when the battery was disconnected; just check the disarm procedure in the owners manual. Pay attention because is possible that the audio system ask the unlock codes.

Hope this helps.

Aug 23, 2012 | 2008 Jeep Wrangler

1 Answer

How can I disable jeep grand cherokee security system


Hi Andrew:
The 1994 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running. I have an '93 GC 5.2L V8...

The following wiring diagram and electronics circuit contains detail schematics of The 1994 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Nov 25, 2011 | 1994 Jeep Grand Cherokee

2 Answers

Pcm trouble codes.


You can either use a auto scan tool to clear the code's, or you can unplug the battery negative cable, if you have a anti-theft system you may have problem's after disconnecting the battery?

Apr 21, 2009 | 2003 Jeep Wrangler

1 Answer

Security system


in the 1994 jeep the anti theft device can be over riden by using key lock/unluck back hatch open and close, then start engine as usual. each time u lock or disconnect battery u must do it again.

Apr 11, 2009 | 1994 Jeep Grand Cherokee

1 Answer

1994 cadillace anti theft system


I just had this same problem with a '96 . do you have a vats key in your '94? you need to bypass the VATS system. read some of the blogs on this site and it will tell you how to do it. I fixed mine with a $2 resistor from radio shack.

Oct 08, 2008 | 1994 Cadillac DeVille

1 Answer

1992 chevy corvettecranks but doe's not start.fuel pump not working but good.fuse good doe's not have power to fuse at all.


The built in factory anti-theft system disables the fuel pump if it is triggered, or this can be caused by a fault in the anti-theft, those are a few of the reasons, arm and dis-arm anti-theft is it working properly? Follow this procedure to check security system:

The Security System is reset by unlocking the driver's door twice with the Ignition Key, but if it does not reset, most likely the Ignition Lock Cylinder has failed. It has small contacts which 'sense' the pellet on the key and transmits that data to the Anti-theft Module. Often the contacts, or the micro wires, break causing the module to think you have no key in there. The ASR may be illuminating since the Security System is active, trouble codes?

Aug 04, 2008 | Chevrolet Corvette Cars & Trucks

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

1,294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...