Question about 1993 Honda Accord

Open Question

Car seem to be pulling hard at 60 mpr - 1993 Honda Accord

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed a blown head gasket on 01 mazda 626. Now it want start and pulled a compression check on it an it has 60 across.


60 seems to be very low, it would have been best to check the valve seats or piston rings, while you head off.

Jun 17, 2014 | Cars & Trucks

1 Answer

My E350 2006 don't go over 40 mpr and don't switch


I have the same problem on my 2007 Mercedes E350, and cant get an accurate answer from any body, every body tell me different things even Mercedes Dealer. Help me!!!

May 01, 2012 | 2007 Mercedes-Benz E350 4Matic Wagon

1 Answer

I have a 2005 chevy trailblazer and speeddometer does not work if in park it stays at 90 mpr then when i drive it goes past 120 mpr what could be the problem


This a fairly common problem with the instrument cluster gauges. All the gauges are driven by stepper motors and these sometimes go bad. If you are capable of removing the cluster from the vehicle, there are vendors on Ebay that repair clusters.

Feb 18, 2011 | 2005 Chevrolet TrailBlazer

1 Answer

2003 town country 3.3 vibration between 40 mpr and 60mph new 1/2 shafts new rotors and pads new right side tie rod front end alinement trans filter and fluid change motor mounts and trans mounts checked...


I have the same problem, but haven't replaced the half shafts. rotation and allignment done after both tie rods replaced Vibration seems to dissapear when letting up on the accelerator
Any help would be appreciated

Oct 20, 2010 | 2003 Chrysler Town & Country

1 Answer

Steering shakes at 60 mpr


Have you had the tire balance checked?

Jul 18, 2010 | 2002 Jaguar X-Type

1 Answer

1989 BMW 735IL CLUSTER GAS ? MILES? NEED RELLAY? MPR YES,RPMS YES....


You need a mother board for your cluster.I would try picknpull. The mother board is the black box on the very bottom of the cluster.pull it out and replace it with a good one.Be sure to reset your odometer for correct mileage.

May 21, 2010 | 1989 BMW 7 Series

1 Answer

Why would a Lincoln Town Car 1994 start shaking as if running out of gas. After driving anywhere from one half mile up to 7 miles check engine light comes on. Seconds later the car starts shaking as if...


hi,

if its a 3.8 v6 then check the EGR valve. the egr valve will get a hole in it an cause a huge vacuumn leak, and cause that. untill you take it in you can plug the vacuumn hose that goes to the EGR valve on the intake manifold, fix it soon.

jm

Dec 03, 2009 | 1994 Lincoln Town Car

4 Answers

Steering wheel vibration at 65 mpr after I had master brake cylinder replaced. I have to pull off to side of road and stop car then start up again and problem stops. Can feel vibration in brake pedal when...


check balance of tires; if ok, have rotors refinished or replaced; most likely warped rotors if you can feel it in the brake pedal when braking

Oct 07, 2009 | 2004 Toyota Solara

1 Answer

Check engine light comes on with speeds of 45 or more what is wrong


you need to pull the diagnostic code and see where it leads. go to local auto parts store and most of them will help you to pull it. its where you start.

Apr 23, 2009 | 1991 Isuzu Pickup

1 Answer

My car doesnt pass 2500 rpm


I tell you how to fix it.
You drive 110.
You crash, and die.
My fault.
No, thanks.

Jul 07, 2017 | 2000 Nissan Altima

Not finding what you are looking for?
1993 Honda Accord Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...