Question about 1993 Toyota Corolla

Open Question

How do i install a blowoff valve to my supercharged 1993 toyota levin?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What size of engine does a 1986 Toyota MR2 have?


their were 3 engines for the gen 1 mr2 a 1.5 --1.6---1.6 supercharged
Toyota MR2 Wikipedia the free encyclopedia

Oct 05, 2016 | 1986 Toyota MR2

1 Answer

What is code , po299' on mitsubish shogun 2008


the following answer is courtsey of OBD-CODES.com OBD Codes Your OBD-II Trouble Codes Repair Site Home Trouble Codes FAQs Forums Store P0299 Turbo / Supercharger Underboost OBD-II Trouble Code Technical Description Turbocharger/Supercharger "A" Underboost Condition What does that mean? The P0299 DTC code refers to a condition where the PCM/ECM (powertrain/engine control module) has detected that the bank "A" or single turbocharger or supercharger is not providing a normal amount of boost. That could be due to a variety of reasons, which we detail below. On a normally operating turbocharged or supercharged engine the air going into the engine is pressurized and that's part of what makes so much power for an engine of it's size. If this code is set, you will likely notice reduced power output. In the case of Ford vehicles, this may apply: "The PCM checks for a minimum throttle intake pressure (TIP) PID reading during engine operation, which indicates an underboost condition. This DTC sets when the PCM detects that the actual throttle intake pressure is less than the desired throttle intake pressure by 4 psi or more for 5 seconds." Symptoms Symptoms of a P0299 DTC may include: MIL (Malfunction indicator lamp) illumination Reduced power output from engine, possibly in a limp mode Unusual sounds from the engine/turbo There would likely be no other symptoms. Potential Causes Potential causes of a P0299 turbo underboost code include: Intake (induction) air restriction or leak Failed or damaged turbocharger (sticking, binding, etc.) Faulty boost/charge pressure sensor Faulty wastegate bypass regulator valve (VW) Low fuel pressure condition (Isuzu) Sticking turbo nozzle control solenoid (Isuzu) Faulty injector control pressure (ICP) sensor (Ford) Low oil pressure (Ford) EGR system fault (Ford) Variable geometry turbocharger (VGT) actuator (Ford) VGT vanes sticking (Ford) Possible Solutions First off, you'll want to repair any other DTC codes if present prior to diagnosing this code. Start with a visual inspection. Inspect the intake air system for cracks, loose or disconnected hoses, restrictions, blockages, etc. Repair or replace as required. If the air induction system tests OK, then you'll want to focus your diagnosis efforts on the charge pressure control, diverter valve (blowoff valve), sensors, regulators, etc. Really at this point you'll want to refer to a vehicle specific detailed repair manual for specific troubleshooting steps. There are some known issues on certain makes and engines so also check out our car repair forums here and search using your keywords. For example, if you search around, you'll find that a common fix for a P0299 in VWs is to replace or repair the diverter valve or wastegate solenoid. On the GM Duramax diesel, this code may mean the turbo housing resonator has failed. If you have a Ford, you'll want to next check the wastegate regulating valve solenoid for correct operation

Read more at: http://www.obd-codes.com/p0299
Copyright OBD-Codes.com
OBD II Trouble Codes Home

Aug 02, 2015 | Cars & Trucks

1 Answer

Installed blowoff valve on Saab 93 2004 but not working


You should not install an open air BOV on SAAB's latter than 1999. Rather you can install a forged aluminum version that still evacuates the boost into in the intake pipe just like the factory version.

Nov 30, 2013 | 2003 Saab 9-3

1 Answer

For toyota mr2


if its a turbo its called a waste gate

Oct 31, 2009 | Toyota MR2 Cars & Trucks

1 Answer

I need a book with all car discriptions


u can go to the toyota dealer and order one or try ebay for a manual ok well i checked on ebay and there was no manual for that vehicle so try the dealership

May 26, 2009 | 1998 Toyota Corolla

1 Answer

1989 Toyota Corolla Levin tyre pressure


all passenger cars run at 32psi front and rear. unless low profile mags and tyres are fitted the run around 36 psi. hope i have helped.

May 16, 2009 | 1989 Toyota Corolla 2 Door

1 Answer

Cooling gas are leeking from compressor safty valve. What are the causes?


Install ac gauges and check the pressures ensure the high side is not over 275psi. If pressure is high  evacuate system recharge w/specified refrigerant and monitor gauges, make sure the cooling fan is working properly. Could be a defective blowoff valve,fan assy/relay,or a restriction in the system. 

May 07, 2009 | 2005 Ford Expedition

1 Answer

Replace door hinges :toyota levin


There is no need to remove the bumper or the fender. Just remove the door to reach the screws for the hinges mounted to the body- fender side.

Nov 15, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
1993 Toyota Corolla Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...