Question about 2005 Suzuki Verona EX

4 Answers

Engine light is on, giving a trouble code po456, on a 2005 suzuki verona, 6 cyclineder what is this.

Posted by on

Ad

4 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 164 Answers

Means small evaporative emmisions leak. there is a vapor leak in the fuel system, either a bad or loose gas cap, cracked filler neck etc. id try the cap first, if not that you can fix yourself. a shop will pressurize the system with nitrogen and smoke and locate the leak in this manner. good luck

Posted on Sep 04, 2009

Testimonial: "found broken vacum line still did not help"

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 97 Answers

Most likely your gas cap has a small leak around the seal which in most cases is unnoticeable. This is a design flaw which usually affects these vehicles between 40-50k miles. An easy cheap remedy is to go to pep boys get a new cap (Stant #11825) for $8-10 install new cap you can either have the code reset or it will cycle through a couple of times with the fault corrected and erase/cancel itelf out. I hope this helps you let me know if you need any further assistance.

Posted on Sep 04, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

EVAP System Small Leak (0.080") Detected

Possible Causes:


EVAP charcoal canister is loaded with fuel or moisture

EVAP canister air valve has failed, or its circuit is shorted

Fuel tank cap is missing, leaking or the wrong part number

Fuel tank is cracked (leaking), or a leak exists in the 'O' ring

Fuel level sensor is damaged or has failed

Fuel pressure control valve is damaged or its circuit is shorted

Fuel pressure sensor is damaged or has failed

Fuel vapor line(s), fuel pipes or hoses are damaged or leaking

PCM has failed

Posted on Sep 04, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,359 Answers

Are you one of those people who TOP OFF the tank when filling up?

When the EVAP recovery system soak with few ounce of gasoline......the trap vapor will take few days escape.

EVAP system is design to handle fuel vapor. Few ounce of gasoline can damage the fuel vapor recovery relay and decrease the service live of the recovery lines.

=========

You can accelerate the process by locating the charcoal canister (near the nose of the car and same side as your gas filler door)

MOVE the car to outdoor.

Disconnect the EVAP line and let it air out by itself.

DO NOT introduce any heat source or fan to speed up the process.

Reconnect this EVAP hose and use a small amount of starting fluid at the intake manifold.


Please post more information by Clicking on the comment link.

I will follow up.

Posted on Dec 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is causing my 2004 suzuki verona to what is causing my 2004 suzuki verona start but dies immediately...if i give it gas and shift quickly i can go but will die as soon as i slow down at a stop


hot and cold engine, both , and restarts hot?
no engine state? or country.
all answers USA cars.

there are no less than 50 causes of stalls.

do you have tools? (meters and gauges and a scan tool)???
id bet not, right? so do say so...
so ill not list all 50 , cans send the list , have one. ask.

ill do the laws of physics, and for mr, otto cycle engine (gas)
1: lost 12vdc to EFI parts. and spark (raw dc power)
2: engine lacks compression. (cylinders) 50 ways to fail just here.
3: lost spark? , failed to do the 60k mile tune up, seems right now?
4: lost fuel or too much fuel. (complex , ask)
5: EGR main valve stuck open. ( clean it)
6: Cat melted, due to #4 too rich. (vacuum test fails, ask)
7; Loss of fresh air to engine , can cause #4 due to packed up air cleaner filtler or ISC air valve stuck closed.

does this help or make you run to the first ASE mech you see.?

Mar 07, 2015 | 2004 Suzuki Verona

1 Answer

06 Suzuki Verona has two upper oxygen sensors is


read your other ANON post first.
Double posted, an again , no engine stated.
is this the I-6, inline SIX? 2.5L

my wild guess is you get DTCs for bank 2, right?

example this? (this is farthest from crank pulley)
Trouble Code: P0050 2.5L I6
HO2S Heater Control Circuit Bank 2 Sensor 1
Number of Trips to Set Code: 2
Trouble Code Conditions:
HO2S-1 heater (bank 2) control circuit is open circuit.

Oct 04, 2014 | 2006 Suzuki Verona

1 Answer

How many quarts of oil does my 2004 suzuki verona hold?


6 quarts will do it.
When its on the stick give the engine a quick run and check again. Especially if you changed the filter

May 20, 2014 | 2004 Suzuki Verona

1 Answer

I have code P1670


obscure. it is.... is not the Verona a Daewoo with a GM engine?
the lame duck?
The Evanda is also rebadged as the Suzuki Verona in North Americal and Chevrolet Epica in other markets.

fixing these cars is no fun, not at all.
there are 2 engines and ECU/PCM used to match (and DTC's)
so is it the daewoo in line 6?or GM Holden 4 cylinder, E-TECH 2.0L
when working on cars, drive line issues) first find out what is under the hood.?
Im sure you know Suzuki shut down in USA? right, and in Canada in 2014, no country stated, so i guess wildly....
im at alldata . com for 6 banger, engine.
no 1670.,it ends at 1668 (2.5L engine)
BTW1, P1xxx codes are factory codes. and can be unique.
P0xxx codes are USA basic codes. EPA/SAE/DOT codes.
P16 means computer output error.

my wild guess is your car has the 4 banger the GM holden engine.
and i dont have DTCs lists for the E-TECH

did you pull that code, or did autozoned.?
did you write i down correctly?

is your engine the L34?
as seen here
http://en.wikipedia.org/wiki/GM_Family_II_engine#L34

Nov 06, 2013 | 2004 Suzuki Verona

2 Answers

2004 suzuki verona emissions issue. Check engine light stays on. Shows no error codes, says mixture lean. Can you give a solution?.


A few things to check:
1. A bad intake manifold gasket
2. A missing O ring gasket between the air filter cover & the MAF sensor.
3. A dirty fuel filter.

What's the code? P0171 & P0174 would indicate a vacuum leak. P0171 could be the MAF sensor. Good luck, I'm still fixing all my Verona's annoying "quirks".

Feb 20, 2012 | 2004 Suzuki Verona

1 Answer

P1668 for 2005 suzuki verona


no question asked, just a number.
are you asking how to diagnose cars?
or want use to print out the 10 pages in FSM book on this?
why not get car serviced, we cant teach car service online.
we dont know what engine you have, there. 2.0L or 2.5L (matters)
sold in USA as Verona, others as Daewoo Evanda
on the 2.5L this code means
the ETC sensor wires fell off sensor (unplugged)
or they are shorted,(mangled)
or the SENSOR is bad, (not weak) bad, open or shorted inside.

Nov 15, 2011 | 2005 Suzuki Verona EX

2 Answers

I NEED TO TAKE 2004 SUZUKI VERONA FOR EMISSION TEST, BUT ENGINE LIGHT STAYS ON, ANY SUGGESTIONS?


you will need that fixed first, have a shop check it out and recommend repairs.

Jan 04, 2011 | 2004 Suzuki Verona

1 Answer

2005 suzuki verona ex check engine light stays on


the check engine light stays on if there is trouble codes in the computer it could just be a simple miss fire that triggered the check engine light to come on i would have a shop or auto parts store check the computer.

Dec 10, 2010 | 2005 Suzuki Verona EX

1 Answer

2004 Suzuki Verona


There is not a fuse for the check engine light.

Mar 14, 2009 | 2004 Suzuki Verona

Not finding what you are looking for?
2005 Suzuki Verona EX Logo

920 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...