Question about 2006 Chevrolet Malibu Maxx

2 Answers

Car wont turn on again.

Error message gos on dash(where the miles go), all Gages turn off. gas-rpm-mph-temp-oil levels go to "0", all sensors go crazy, low fuel light,-check coolant- go on. and this is all while its running, once i turn the car OFF it will not turn on- error messege stays on, when i turn the key u can here the fuel injector,, i've tryed to take the battery off and put it back on-it theen turned off on my way home it did it again and now it wont turn on at all.

Posted by on

  • jorge rocha Sep 05, 2009

    today when i was driving around it did it again, it only turned off after i let it sit for about 3hrs with out the battery connect + & - sides. i got it to turn on, but like not even an hr later it everything went haywire.. and well i drove it over to autozone, for them to check it out.. of course i didnt want to turn it off, the tryed to connect to it but said my "computer wont allow them to connect to the car" no the less i came home and disconnected the battery again, had the fuse box check, everythin was fine, as well as all the wireing. car runs great with or with out this glitch..

  • jorge rocha Sep 05, 2009

    it just wont turn back on

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I would say it sounds like the computer (ecu) is going

Posted on Nov 07, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chevrolet Expert
  • 332 Answers

I`m going o take a shot in he dark on this one it might be the alternator and lets hope its not the brain box

Posted on Sep 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mph, gas, and temp gauges are not working


That's why you don't let you husband work on your car ! Unless he does it for a living .. For MPH there is a VSS - vehicle speed sensor , for the gas there is a sending unit in the fuel tank, for the temp. gauge there is a temp. sensor located in coolant stream on the engine .You more then likely need to have you instrument cluster repaired . GM had a problem with step motors inside the instrument cluster . A step motor is what controls the individual gauge. The sensors are all inputs to the PCM - powertrain control module (engine computer ) .
Engine Coolant Temperature Gage
The IPC displays the engine coolant temperature as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the engine coolant temperature. The engine coolant temperature gage defaults to C or below if:
?€¢
The PCM detects a malfunction in the engine coolant temperature sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

Fuel Gage
The IPC displays the fuel level as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the fuel level percent. The fuel gage defaults to empty if:
?€¢
The PCM detects a malfunction in the fuel level sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

When the fuel level is less than 14% (84ohms), the low fuel indicator illuminates.
Odometer
The IPC contains a season odometer and a trip odometer. Momentarily press the trip select/reset switch in order to toggle between the season odometer and the trip odometer. Press the trip select/reset switch for greater than 1.5 seconds, while the trip odometer is displayed, in order to reset the trip odometer. The IPC displays the vehicle mileage and trip mileage as determined by the IPC. The IPC calculates the mileage based on the vehicle speed information from the PCM. The odometer will display 'error' if an internal IPC memory failure is detected.
PRNDL Display
The IPC displays the selected gear position as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the gear position. The PRNDL display shall flash all gear positions if:
?€¢
The PCM detects a malfunction in the transmission range switch circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

Speedometer
The IPC displays the vehicle speed based on the information from the PCM. The PCM converts the data from the vehicle speed sensor to a 4000 pulses per mile signal. The IPC uses the vehicle speed signal circuit from the PCM in order to calculate the vehicle speed. The speedometer defaults to 0 mph (0 kph) if a malfunction in the vehicle speed sensor circuit exists.
Tachometer
The IPC displays the engine speed as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the engine speed. The tachometer will default to 0 rpm if:
?€¢
The PCM detects a malfunction in the engine speed sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

May 22, 2016 | 2002 Buick Century

1 Answer

Switching gears from 1st to 2nd


there is a computer that controls your rpm gauge, your speedo, and your shift. check that and your speed sensor. the sensor is faster and easier.

Jul 26, 2009 | 2004 Nissan Maxima

3 Answers

Dying, not starting after it's been warmed up. Runs beautiful on cold engine. Replaced plugs, wire, cap, rotor and crank position sensor, no luck.


Your car cold start valve puts more gas into the system keeping your engine running higher RPM. When you car warms up, the cold start valve will stop working and your car RPM will drop. What you could have is a vacuum hose disconnected which puts more air into your engine - therefore when you press on the gas pedal, your engine would shut off or you find lack of power and then shut off.

Mar 27, 2015 | Cars & Trucks

1 Answer

I have Civic 2001 with 160,000 miles on it. i have problem when i am driving on high way on 80/mph rpm stay on 2800 and after 5 minuts rpm goes to 3500 and i feel loud noise like engine is taking more...


If the car type is manual transmission:
- Perform the clutch and pressure plate test.
PROCEDURE:
- Pull up the hand brake, shift the lever to 1st gear, rev up to 2000 rpm, release the clutch pedal at once.
- If the engine does not stall, replace the clutch, pressure plate, clutch bearing, regrind the fly wheel and pressure plate precisely.
- If the engine stalls, the clutch system is OK and do not need any clutch system repairing.
- If the clutch system is OK, check vacuum leaks through intake manifold, vacuum hoses, PCV valve and throttle control cable adjustment, MAP sensor and Throttle Plate Position sensor adjustment (9.8 percent or 0 degrees at TP sensor fully closed position).

If the car type is automatic transmission:
- Check the transmission control cable adjustment.
- Check vacuum leaks through intake manifold, vacuum hoses, PCV valve and throttle control cable adjustment, MAP sensor and Throttle Plate Position sensor adjustment (9.8 percent or 0 degrees at TP sensor fully closed position).
- Check the Automatic Transmission Fluid level in the transmission with the car on level floor, engine start, gear lever in P.
If the problem persists, contact a competent technician or service personnel.

Jan 19, 2014 | 2001 Honda Civic

1 Answer

Humming sound at around RPM level 2 car


this could be a bad wheel bearing.

May 21, 2013 | 2005 Audi A4

1 Answer

Gages and dash lights


Have you checked the fuses? Look in the owner's manual for the locations... you might have just blown one.

Aug 15, 2009 | 2000 Oldsmobile Intrigue

1 Answer

97 grand am instrument cluster flicking


replace the gages their malfunctioning ,check the wires for they are grounded.

Jul 20, 2009 | 1997 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...