Question about 2000 Chevrolet Impala

1 Answer

I dont know wher the fuel injectors go on a 3.8 chevy impala 2000

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 124 Answers

They go to the lower intake mainfold.
They are located on the fuel rail.

Posted on Sep 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is my fuel injector on my Chevy 08 Impala k


I'm not sure of engine size? My info says you have to remove upper intake manifold to get at fuel injectors. The fuel injectors are attached to fuel rail.

What is the problem? Have you done any testing?
25997770-ngvlufik3deka04qh2ue4e3p-4-0_0.jpg

Dec 07, 2015 | Cars & Trucks

1 Answer

What can cause a cylinder 1 misfire in a 2003 Chevy impala with a 3.4 liter engine


Misfire reasons.
Bad ignition coil (there are 3 of them), bad spark plug, bad spark plug wire (most common) defective fuel injector, intake manifold vacuum leak, low cylinder pressure due to burnt valves or scored cylinder walls.

Sep 25, 2011 | 2003 Chevrolet Impala

1 Answer

My 2000 chevy impala starts and runs for a bout 2 seconds. I've been told its the pass 2 security system I tried to bypass that it did not work so since the car has 2000000 thousand miles I thought I...


Well, you wont be able to hotwire it direct. Thats why the Passlock is there. The TDM (theft deterrent module-also called Body control module- or computer) must receive and send the correct signal to let the injectors work. Thats why you car is shutting down. I dont know what you used as a BYPASS, but there is a really great one here that illiminates ALL parts of this system permanently. Read through this link and check out the PERMANENT FIX part. Sounds like this is what you need. Trust me on this one, you will NEVER be able to hotwire that thing, They are wound REALLY tight, and the Passlock system has its fingers in more than just the starter, it allows fuel doors to open, injectors to spray, and sometimes spark in general.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

2000 2001 2002 2003 2004 2005 Chevrolet Impala Passlock Security problem years

tayjoejoe_14.jpg

Jul 08, 2011 | Chevrolet Impala Cars & Trucks

2 Answers

What all could cause a miss in a 2000 chevy impala engine


Bad spark plugs, spark plug wires or ignition coils, or faulty injectors

Feb 24, 2011 | 2000 Chevrolet Impala

2 Answers

Where is the fuel filter on a 2000 chevy impala


I have a 2000 chevy impala and i have replaced wires and ignition coils, it starts ok, but when you drive it , it drives rough and stalls.do you know what this may be?

Jan 31, 2011 | 2000 Chevrolet Impala

1 Answer

How do you replace the mass air flow sensor i want to do it myself the guy at auto zone said it was easy i have a 2000 impala 3.8


3.8L Engine To Remove:
MAF Location 93174g17.gif

  1. Disconnect the battery ground cable.
  2. Remove the fuel injector cover.
  3. Disconnect the mass air flow (MAF) sensor electrical connector.
  4. Remove the MAF sensor mounting screws.
  5. Remove the MAF sensor from the throttle body.
To Install:
  1. Position the MAF sensor on the throttle body.
  2. Install the MAF sensor mounting screws. Tighten the mounting screws to 27 in lb (3 Nm).
  3. Connect the mass air flow (MAF) sensor electrical connector.
  4. Install the fuel injector cover.
  5. Connect the battery ground cable.
prev.gif next.gif

Nov 12, 2010 | 2000 Chevrolet Impala

1 Answer

My 2005 Chevy Impala smells gasy when ever started and sometimes after idling for awhile.


SMELL GAS YOU NEED CHECK ALL FUEL LINES UNDER THE HOOD IN THE ENGINE COMPARTMENT.IF GAS IS STRONG UNDER HOOD YOU DONT SEE LEAKING FUEL LINES.YOUR FUEL RAIL FUEL INJECTORS LEAKING OR FUEL PRESSURE REGULATOR O - RING OR DIAPHRAM LEAKING GAS.IF FIND NO LEAKS UNDER THE HOOD CHECK FUEL LINES UNDER CAR FROM ENGINE TO FUEL TANK FOR LEAKS.IF ALL IS GOOD YOUR EVAPORATIVE CANISTER SOAKED WITH GAS OR YOUR EMISSION EVAPORATIVE SYSTEM NOT WORKING. DEALERSHIP HAS TO CHECK AND FIX.

Jul 03, 2010 | 2005 Chevrolet Impala

2 Answers

Firing order for plugs and wires....on a v6 3800 2000 impala


For the 2000 Chevrolet Impala 3.8L V6:

Firing Order:
1-6-5-4-3-2

Cylinders:
.....(back).....
|...2...4...6...|
___________
|...1...3...5...|
.....(front)

Ignition Coil Connections:
(back)
o <---6
___
o <---3
o <---2
___
o <---5
o <---4
___
o <---1
(front)

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Apr 18, 2010 | 2000 Chevrolet Impala

2 Answers

My 2000 Chevy Impala fuel gauge reads empty.


sending unit on fuel pump is bad, the sending unit shorts out gauge will go to empty or full, never read right, turn on switch ,it goes to full or empty, ,check the pump,hope this helps,thanks robert b.

Jun 27, 2009 | 2000 Chevrolet Impala

1 Answer

2000 Impala:Hard start and couple times Idles extremly high


The car has OBD2 technology, You wont be able to tell without special tools. The ignition components, timing, CKP & CMP sensor, fuel line pressure, misfires, and fuel quality all need to be looked at. But to answer your question, "over 3x cranking' could be timing or fuel pressure. A bad IAC would cause a rough idle, and if the injectors were bad then it would cause a misfire too.

Jun 03, 2009 | 2000 Chevrolet Impala

Not finding what you are looking for?
2000 Chevrolet Impala Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...