Question about 2002 Dodge Caravan

Open Question

2002 dodge caravan will not crank over No com. to PCM changed & disconected crank & cam sensor Changed PCM still the same trouble

Posted by on

  • card429 Sep 04, 2009

    yes it is programed . no theft , only remote keyless ,also changed crank & cam sensor same trouble
    Eric

  • robert rusiniak May 11, 2010

    when you changed the pcm did you get it programmed. If not and it has factory theft you may have fried your body control module.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace the PCM on a 2002 dodge caravan 2.4L engine?


First set park brake,locate PCM in van ...Compare new PCM with old to be sure new one is correct part..You will small tube of dielectric lube..WEAR SAFETY GLASSES..,Disconnect negative battery cable...wipe and blow dust/contamination from around wiring harness plugs...Remove plugs from PCM...,Remove old PCM..lightly lube connecter pins with cotton swab..,plug in wiring harness connectors..re-connect battery cable...Complete..............BROOKS..

Oct 08, 2014 | 2002 Dodge Caravan

1 Answer

2000 Grand Caravan cranks but doesn't run. If I bypass the automatic shut-down relay it'll run for about 3 seconds, but starts surging and conks out. Both the cam & crank position sensors test okay....


the pcm energizes that relay. should be a dark blue wire with a yellow stripe going from pcm pin 67 to pin 8 on power dist center. check all fuses then check wire. Is the check engine light on with key on? Possible bad pcm.

Dec 04, 2013 | 2000 Dodge Grand Caravan

1 Answer

3.3 dodge caravan spark cuts off pcm coilpack cam and crank sensor have all been changed all wires are fine and spark still cuts off


Cam and crank sensors must be gapped right. The hold down is sloted so it can be moved closer or further away. New sensor should have come with a small felt pad on the end. Push the sensor in until it stops. If the gap is to much you may get an internmitent spark. ( I have also gotten bad cam sensors right out of the box)

Jan 23, 2013 | Cars & Trucks

1 Answer

Misfire on 2004 dodge grand caravan


try checking the contacts and connection plugs on the crank and cam sensors

May 19, 2012 | 2004 Dodge Grand Caravan

2 Answers

1999 dodge caravan new pcm new crank and cam sensor new coil pack new flexplate still no spark, scannner show sync problem, any ideas


If you have replace new cam sensor with no sparks and the coil are good putting out 12 volt, my guess would be the computer it self faulty. cam sensor sense the cam turning and send info to computer telling computer to disperse the charge from the coil pack to the plugs assuming relay, cam sensor, coil, plugs, and wires are good. make sure the cam sensor is put in properly and position.

Aug 28, 2009 | 1999 Dodge Caravan

1 Answer

2003 Dodge Caravan 3.3 No Crank, No Start


replace the neutral safty switch

Aug 28, 2009 | 2003 Dodge Caravan

1 Answer

2003 Caravan No Crank, 3.3L


This is a bad PCM. Try to disconnect the security system first and if it still does not start then it is the PCM.

Aug 09, 2008 | 2003 Dodge Caravan

Not finding what you are looking for?
2002 Dodge Caravan Logo

Related Topics:

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...