Question about Ford Mustang

Open Question

2000 Ford Mustang auto v6. Shifts fine 1-3 and when it lands on 4th trying to go to 5th it will not shift it will just stay at high rpms until it starts to slow down and the rpms will go down very slowly even when i take my foot off the gas

Posted by on

  • 1 more comment 
  • xsoulscarz53 Sep 03, 2009

    When my car goes into overdrive on 4th gear, it will not shift too 5th. It will just keep going onto higher rpms and the rpms will go down very slowly even when i have my foot off the gas. Normally if it were at 2000 rpms and i let go of the gas it would go back to around 1100 rpms.

  • yadayada
    yadayada May 11, 2010

    what system touble codes do u have, can't help until u have them checked, the key to repairing this may be in a code in the memory of the computer.

  • yadayada
    yadayada May 11, 2010

    what trouble codes do you have?

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

1 Answer

Does Shift solenoid A&B control shifting into 5th gear on an automatic transmission?


First check the transmission MIL code , that will tell you if it is the Over Drive lock solenoid mal functioning , Do a tranny oil change with filter ,then replace fifth gear pressure solenoid , when you are there already .

Jan 23, 2013 | 2000 Cadillac Seville

1 Answer

I have a 2000 hundai accent and when i shift into 4th gear it pops back out again


The problem is inside the box, could be a sliding sleeve and gear

Jun 25, 2012 | 2000 Hyundai Accent

1 Answer

My 1995 sentra shifts fine in all gears but when i accelerate in 4th or 5th gear it the rpms wind up and the car doednt real respond feels like its in the accelerater do i need a new clutch


Sounds like the clutch is slipping. If the clutch is bad, it will slip in high gears (4th & 5th) but seem to work fine in lower gears. Clutch probably needs replaced but have a mechanic check it out first because it's a fairly expensive job. If your clutch is actuated via a cable (not hydraulic), it may just need adjusting.

Dec 10, 2010 | Nissan Sentra Cars & Trucks

1 Answer

I have a 93 ford mustang sometimes when it shifts from 2nd into drive it reves an extra 500 rpms becors it shifts into drive. i chamged the tranny fluid and filter, and vacume assist on the side of the...


I also have a '93 with a 2.3. I added Lucas transmission treatment (about 12 dollars) 2 years ago and it's still fine. However, it sounds like one of the clutches is worn.

Dec 02, 2010 | 1993 Ford Mustang

1 Answer

When trans shifts into overdrive it shifts at high rpms?


No not likely. Is the 3-4 shift rough? What speed are you going when it shifts into 4th? It likely just needs the T.V. cable adjusted.

Jun 24, 2009 | 1992 Chevrolet Camaro

1 Answer

Auto transmission does not shift into 1st gear properly


Try some Seafoam brand trans tune it might help.
Even if it dosen't it's a cheap experment.

Dec 04, 2008 | 1991 Suzuki Sidekick

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...