Question about 1999 Dodge Durango

1 Answer

Starts on runs then dies and getting a no bus flashes on

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 164 Answers

This means no communication with the ecm. you have a power loss issue. check the common easy one.go in the engine compartment fuse box and look for a BOLTED juntion on the incoming power supply to the box. they lossen up alot and get corroded and burnt from arcing. clean tighten and try. if not then you have wireing gremlins elsewhere common too is in the steering colum but with the air bag circuits there i cannot advise you on this and will need to go in for service. good luck!

Posted on Sep 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wat no bus mean


Hi Elizabeth, the "No Bus Message" means you have a sensor or something else bringing down the BUS on your vehicle and sometimes when this happens on certain vehicles it want allow the vehicle to start and run. Then only way to figure out what is brinin g the BUS down is when the message appears then don't turn the key off, instead unplug one thing at a time until the message goes away, then you have found the thing thats brining it down. Hope this helps and have an awesome day Elizabeth!

May 20, 2014 | 2000 Dodge Ram 1500 Truck

1 Answer

2002 ram 2500 would just die while running. Had no bus code. Replaced pcm and truck started then died right after starting. Any ideas?


check catalatic converter make sure its not plugged or hit it and see if its broke in the inside also check mass air flow sensor

Jan 29, 2014 | 1999 Dodge Ram

1 Answer

No bus,after battery died,2006 dodge srtatus


The Battery has gone flat. When you tried to jump start it, this did not change the battery state its still flat.
I bet you will get the same code on the scanner if you remove the battery. Take the battery out and charge it with a battery charger overnight, then try it again.

Dec 28, 2013 | Dodge Cars & Trucks

1 Answer

Dakota - 2001, started, died and won't start. all dash indicators light as normal except odometer says "No Bus."


Hi, if odometer say no bus you are loosing your bus signal some were ,with out a bus signal the car not going to run the bus signal runs to every module on your truck. This could be as easy as a blow en fuse to a wire shorted out or a bad module . Depends on your know how around cars . If your not sure you should take to local shop or dealer. If i can help you further just re post.
Thanks dodge tec

Jan 02, 2011 | 2001 Dodge Dakota

1 Answer

1994 ford e-450 shuttle bus 7.3 liter non turbo


change the delivery fuel pump right before the injector pump should 100% solve the problem. thanks

Mar 26, 2010 | 2009 Ford F-450 Super Duty

1 Answer

1999 durango 318 no bus error,


Ussually caused by internall ecm failure.

Jun 16, 2009 | 1999 Dodge Durango

1 Answer

Will start then die.


if it starts runs and dies instantly, the fuel pump could be the culprit, its getting the signal to sqirt fuel to start but then no voltage to continue pressure.. check fuel pump and also worse case senerio is the ECU (main computer could be bad)

Apr 24, 2009 | 2001 Dodge Dakota

1 Answer

My van dies every now and then


well all i know is that there is a power bus line that controls the entrine cars electronics. that wire runs under the dash you can follow the wires from that fuse and shake the wire to see if you have a short or something i had my sah apart and touched that huge wire harness (bus) and my fuse blew...so hope this helps Mike

May 14, 2008 | 2000 Dodge Ram Maxi

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8274 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...