Central locking does not work

no all is related to one fuse you can remove the door internal controls and decore and remove center lock motor plug and test two connectors with multimeter with set on 12v and then lock un lock door and check the reading of the multimeter if it read signal then all plugs and wires from central lock control unit to the door central lock unit is okay it this cae you have to replace the door central lock unit with the same if no signal is readed while you lock unlock the door then you have to check central control unit and all wire plus out of it to the door plug

2- you can remove central control unit from driver door and test it in passenger door (usually the same unit ) if it works with lock unlock its then the replaced unit is faulty and needs to be replaced if it not work then check plugs wires from central lock unit (usually found inside driver door ) to the central lock unit in passenger door

3- check signal for said door fro the output of central door unit if no signal then it mean that faulty central lock control unit

http://www.manualowl.com Hope this helps! Jimmy

You will need to replace the driver door switch. You can try to pick a switch up from the dealer or a local car wrecker (i.e. Pick-n-Pull). It will involve learning to take apart the door trim panel.

If the key turns in the lock, but does nothing, then the linkage has become disconnected or broken. The key is mechanical to the lock and the lock has a electrical switch to operate the central locking unit. Could be a simple broken clip from the lock barrel. Hope this helps

Did you find a solution to this A's I have exactly the same problem

Hi:
It is extremely difficult to remove the door panel with the door closed. You mentioned that you can unlock the door with a key, so does the door still open and close once unlocked? You most likely just need to replace the power door lock solenoid, as when they fail, they usually sieze up, and make manual lock unlocking difficult.

turn key twice when opening, ie turn right. once drivers door will unlock, turn twice passengers doors will unlock, and locking is turn anti clock wise once will lock all doors, turn twice will set door dead locks.dead locks will stop openand lock internal button working and handle from opening door. the same actions can be applied to the remote one press drivers door, two press passenger doors, press and hold unlock button for 5 seconds and rear window will open.

drivers central door locking module is kaput and needs flinging as far as you can then replace it with a new one or a salvaged one

hello,good day,seems your have a bad contact on driver and passenger switch door actuator,maybe loose contact or mechanical defect,which not sending a signal to your central locking pump,try to remove your rear seat,look your pump,right side,driving direction,lock and unlock your car,observe your pump is working,if not,check or replaces your switch door actuator,ty

1st wind the glass down and turn the key in the driver door twice in clockwise direction to lock, at the sound of the second click try try opening the door thru the window (passenger) manually. you will need to pull the knob twice before it opens. you can get all the passenger doors open this way until you decide to change central lock system. To activate the remote; insert the key into driver door while pressing the lock or unlock button on the remote for at least five-ten seconds which should get it functioning normally again. hope this helps. it worked on mine.