I need to set up and adjust xenon headlights for a

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Find your solution from bellow

» Mazda ( 3781 Solution )
» Mercury ( 8762 Solution )
» Mitsubishi ( 4765 Solution )
» Nissan ( 7654 Solution )
» Oldsmobile ( 2467 Solution )
» Pontiac (1986 Solution )
» Saturn ( 3997 Solution )
» Subaru ( 4225 Solution )
» Suzuki ( 4832 Solution )
» BMW ( 3876 Solution )
» Buick ( 2987 Solution )
» Chevrolet (12345 Solution )
» Chrysler ( 3456 Solution )
» Dodge ( 4765 Solution )
» Ford ( 11345 Solution )
» GMC ( 6754 Solution )
» Honda ( 8943 Solution )
» Hyundai ( 4187 Solution )
» Jaguar ( 2876 Solution )
» Lincoln ( 3346 Solution )
» Toyota ( 9761 Solution )
» Volkswagen ( 4681 Solution )
» Volvo ( 2875 Solution )

104.17