how to tune twin carbs on a mini from start ? the car wont start unless i use easy start then runs rough and wont idle im not to clued up on these 14/ su carbs any tips? its the old one not bmw
First***Stop using starting fluid*** It will destroy your engine.
To set up the carbs, you will need to buy a vacuum balancer. This is a device that will show you how much downdraft each carb has. You then, have to adjust the linkage, so that they are the same. After that, you will need to adjust the fuel mix.
All in all, if you're not experienced in this, it is best left to a carburator shop, not most garages.
hi, do you have a diagram or cd that shows how the rear radius arms fit it the sub frame i.e shows...
(More)
hi, do you have a diagram or cd that shows how the rear radius arms fit it the sub frame i.e shows all nuts and bolts and were they go as i have just took on some oneelses projet and i think all the nuts and bolts are not there thanks for your time, jay
I have a 1960 MGA 1600 with H4 SU carbs. When adjust how rich or lean which direction do I loosen or...
(More)
I have a 1960 MGA 1600 with H4 SU carbs. When adjust how rich or lean which direction do I loosen or tighten the nut for each. I assume that in or towards the card is lean and out or away from the card is rich?? scarsz
is it easier to replace rear wheel arches on a austin mini advantage or get them welded to pass an...
(More)
is it easier to replace rear wheel arches on a austin mini advantage or get them welded to pass an MOT, which would be cheaper and faster? There was no option to verify the model i have. mine is a E reg
i have a 1987 mini advantage and none of the lights work at all apart from the break lights when i...
(More)
i have a 1987 mini advantage and none of the lights work at all apart from the break lights when i apply the breaks and thats it. what do i have to do. i have replaced all the fusses in the fuse box and also replaced the 12volt relay.